Craft Master Sewing Machines - Page 2 - Recent Questions, Troubleshooting & Support

Make sure you have the correct needle and thread solution for your fabric. Check your manual there is a chart that states exactly what you need in that regard.

Clean the bobbin and chase. Look for any bits of stuck thread. If that doesn't work, re-thread the top and bobbin. If that doesn't work, take the needle out and re-insert making sure it is the correct way.

If you have you instruction manual look in there. If not, your sewing machine was distributed by Sears. Gather numbers from the machine (on the label on the back typically) and search for the instruction manual at parts.sears.comGood luck.

check with these sites about the part,, you'll have to email themand ask them about the partsewvacdoctor.coma1sewingmachines.com

If you can't manage to replace the blades It would pay to have them sharpened professionally.

Hi. Loops on the underside of the fabric are generally caused by the upper tension being too loose. Use a size 12 needle, and size 50 thread with different colors in the upper thread and in the bobbin. Sew an inch or so, look at the stitch and adjust, tightening the tension just a bit at a time.

There's more detail in the tip I wrote about adjusting tension.

Hope this helps!

Robbie

No it should be part of the machine

Hi seeyalaterut...

Sorry I could not find a free manual, but I did find a website where you can purchase one
Please take time to rate me

http://www.sewvacdirect.com/craftmastermanuals.html