Craft Master Sewing Machines - Recent Questions, Troubleshooting & Support


try the manufacturer and manuals on line .com.

Craft Master... | Answered on Apr 04, 2019


it will all depend on the plug into the machine
take the control you have now to any sewing machine service agent and see it they can help

Craft Master... | Answered on Jul 14, 2016


The Craft master 4300 was also sold with the Janome HD1000 label. Thus the Janome manual should help you. That manual is available from Janome at the HD1000 product page: http://janome.com/en/machines/sewing/hd1000/ . The direct link is http://janome.com/siteassets/support/manuals/economy-models/inst-book-hd-1000engfrsp.pdf .

I hope this helps.

Cindy Wells

Craft Master... | Answered on May 18, 2016


Try these people

http://www.sewingpartsonline.com/assorted-needle-set-5pk-janome-200343004.aspx

Craft Master... | Answered on Nov 25, 2015


i was able to find one at www.ifixmachines.com

Craft Master... | Answered on Nov 07, 2015


There are several ways to order a new craft master 4700 machine is by Internet, any stores that sell these brands of machines, or go to a particular material store and they can help you to order the sewing machine you want. It always helps to have a variety of places one can go to get help in ordering the right thing that one wants.

Craft Master... | Answered on Mar 05, 2015


I dont have a fancy machine but any time Ive experienced this problem I do 1 of 2 things. First I check for bits of thread stuck inside till I removed the bobin case again and discovered the thread way underneath there. Second, if that didnt fix it I rewind my bobbin. Dont know if either would work in your situation. Good Luck.

Craft Master... | Answered on Jan 26, 2015


try these sites, you'll have to call them or email them
sewvacdoctor.com
a1sewingmachines.com

Craft Master... | Answered on May 06, 2014


There is something called limit switch adjustments. They should be on the side of the opener. If the opener is not going up fully, increase the up limit by turning the up screw. Use a flat head screw driver only. 1 full turn of the screw gives you 2in of travel. Same for the down. If the door is not going down fully increase the down limit by turning the screw.

Craft Master 300... | Answered on Dec 03, 2013

Not finding what you are looking for?
Craft Master Logo

44 questions posted

Ask a Question

Usually answered in minutes!

Top Craft Master Sewing Machines Experts

Kelley Buchanan
Kelley Buchanan

Level 2 Expert

130 Answers

Cindy Wells

Level 3 Expert

5908 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

27230 Answers

Are you a Craft Master Sewing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...