Clarke Power Products Welding Tools - Answered Questions & Fixed Issues

A good sand trap louver supplier in UAE, will provide you the product, customizing the requirements of the buildings, members and work of the office. In HVAC system sand trap louver are used to take the fresh air in as they are designed to separate particles of sand and dust at low air velocity.

1] Remove the power cable from the power. (socket on the wall) remove the top cover there should be a fuse located on the wiring panel.
2] perform all your house keping- like, all plugs and socket are tight, the correct contact tip with the the right wire size, roller/s are also the correct ones for the wire size and are turning if they are turning but not feeding the wire, then, the rollers need to be tightend , get back to us.

Check your wire speed theostat (potentiometer), that could be the reason there is no power for the motor drive.

Hi:

You need at leat a 20 amp circuit breaker, but 30 will be better.

Substitute your clark tips for Tweco ones, which are available at all welding stores. Find your nearest Praxair location in the website www.praxair.com.
Part number os TWE 11-30 or TWE 11-35 depending on the size of your wire .030 or .035.

Hi there,
Tig is very brite.If your seeing spots I would try another hood for awhile.If the battery is to weak or you can't adjust up to shade 12 for tig it can be very hard on your eyes.I would try a regular hood on some scrap and see how that works.I couldn't change the battery in my hood so I just had to buy another one.One other thing check for leaks in your hood.You've already done that more than likely.
Do you need a cheater lens?

trigger switch wires broken in the cable ground wire not connected to the job

Call HF at 1-800-444-3353. They call it a "gas diffuser". 2 of them cost me $26 delivered.

Your rectifier is going bad.

Can use argon/co2 mix or CO2 the wire usually has the gas named on the lable

i put a new motor on the welder an i have 9 to 12 vote coming to the motor but the motor wont run all works but the motor

You take it to a welding supply, that
sells that brand, and get help

Check internal fuses and breakers first. Then see if the contactors are closing. If they are not check the 24 volt contacter for coil continuity. If that is okay, check for voltage at the wire feed motor with an analog meter. Put it in a plstic bag and tape the bag where the test leads come out- there is a big magnet in the movement. Keep the meter in the bag to protect it, but check the motor to see if it is seeing power impulses from the control board. If it is not gettin pulsed power when trigger is pressed, suspect a failure of the SCRs on the control board.

Your local Clarke distributor should have it. Otherwise Check Ebay or if you have a tool repair company in your area.

if it is just not feeding wire, check the tension on feed wheel. Make sure it turns when trigger is pressed. Also make sure you have gas with solid wire. If you have cored wire gas is not needed.

Check thermal overload. Also make sure the ground clamp connection is sound.

No. Not with the spool up on the gun. It is one of the few flux core specific welders. This is not to say you could not try. the hard part is the plumbing between the gun and the main box. If you can get that figured out it would otherwise be the same components as other MIG welders.

It is likely the SCR's failed. It is much cheaper to replace those than the entire board. Also look for bulging electrolytic capacitors as they would indicate a shorted condition as well.

Increase Voltage.

release the tension from the WFR, pull the trigger and check the shaft that the rollers are attached is spinning if yes then the woodruff key is either missing or broken if no then the drive motor needs looking at, the shaft may have broken further along. get an electrician to check it out.