Cisco Computers & Internet - Page 8 - Recent Questions, Troubleshooting & Support

when the router looses connection, it is best to just leave it as it tries to reconnect automatically the blinking lights is the communication process and when connection is made for each section the light stays full on there should be a on/off button that you just press to restart the searching process or a reset button under a small hole that you use a paper clip to gently press to reset remember that it is not always the router that looses the connection but the server that it is connecting to

What errors are you getting when you try to play?

http://www.4cnd.com/i-can-t-setup-a-wpa-wpa2-personal-security-setting-on-wrt54g-dx6GokeP.html Wireless LAN Controller WLC Configuration Best Practices

login into the router and add the printer mac address to your mac address filter table

If you have done it properly there is no need to bridge networks because there should only be one. The entire idea of a repeater is to simply pick up the signal from the first router and rebroadcast the signal.If you had included the model of the repeater I could have been more specific but as it is, read this: Linksys Official Support Configuring an Access Point as wireless repeater

flash_init first, then load_helper should work.

Hi andreas, your webcam win7 software can be found at: Driver Update Software for XP Vista 7 8. Enjoy

When the router first starts booting you need keep hitting the break sequence which should be crtl+F6 and that should bring you to ROMMON mode. you should get a prompt rommon 1>, that means you did it right. Now you need to change the configuration registers to 0x2142 by typing "confreg 0x2142". then type reset to restart the router. It should now ignore the saved config. hit crtl+c to cancel the initial setup, type "enable" to get to the enable prompt. Next type "copy startup-config running-config" to copy the startup configuration to the running configuration. Next type "configure terminal" to enter global configuration mode. Now you can type "enable secret <password>" to change the password to what you want. Last you need to change the config registers back to 0x2102 by entering the command config-register 0x2102.

Connect to http://192.168.1.1/The default password is "admin". No username required. If you don't remember the correct password and you don't want to use some brute-force cracking software the only option is to reset the router pressing reset for 30 seconds. After that everything should be back to factory defaults including the default password. If you need any kind of technical assistance you can contact support cell at here