Chevrolet Toys - Page 3 - Recent Questions, Troubleshooting & Support

cddcd

You have too much gas in the system and the high pressure side is stopping the clutch from working.

40-60psi at 1500 rpm

saturate the cylinder in cleaner/solvant.squirt some graphite into the cyl. after reinstillation.

I had problem with tranny cause by TPS sensor.when i replace was OK.

Have a visual first up - this sounds like the plastic guard housing scraping on the wheel (this is fairly common) you will see scuffing / wear on the plastic - You can cut off loose plastic and / or replace. I did have a stone caught between my brake pad and and disc once which make a horrendous noise. A visual inspection should lead you in the right direction.

Check blower motor fuse....if fuse is good.....replace blower motor.

If the Insanity game is the one with 4 pegs each of two colors in a wood board with 10 holes and goal is to switch the colored pegs from one side to other without going backwards, then solution is simple. Assuming the one set of pegs are A, B, C, D and other set are 1, 2, 3, 4 and the blank spots are designated with an O:ABCDOO1234ABODC01234ABODC1O234ABODO1C234ABOOD1C234then i did multiple moves at once but you should be able to see those to end up at:AOB1D2C3O4then more jumping in sequence to get to:A1B2D3C4OOanother series of jumps:O1A2B3D4COanother series of jumps:O1O2A3B4DCthen last set of jumps and sliding over:1234OOABCD

check and replace transmission clutch

check relays and turn signal-flasher. flasher for turn signal is separated to the hazard flasher.

hole in muffler or catlitic converter or in one of the pipes