Chevrolet Logo

Chevrolet Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 2K Products
  • 578K Answers
  • 8M Views

Check that all bulbs light up, one could be burnd out, Check fuse, find turn signal fuse location in the owners manual and change it if blown. If all is OK, then probable signal switch in column needs to be replaced but most times its the fuse.

Chevrolet Cars &... | Answered on Mar 27, 2019


I take help from online websites like reliable-store that have this service like helping in repair some like reliable-store have instant help.. oth ers are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

Chevrolet S 10... | Answered on Mar 27, 2019


If you are talking about the rack-and-pinion, yes it is fairly complicated. Check YouTube. You will need a front end alignment afterwards.

2011 Chevrolet... | Answered on Mar 27, 2019


This problem may be caused by the daytime running lamp ambient light sensor or possibly a body control module issue. There is a testing process which could be performed to assist you or the shop making the repairs.A scan tool capable of reading the body control module will be necessary to perform the testing. First check the bcm for any stored codes.If anything is present please let me know so we can follow up on them. If no codes are present there is another testing process that can be tried.A scan tool will be necessary for this testing as well.Please keep me updated so we can assist you in correcting your issue. Do this testing after it is not working.
  • Cover the ambient light sensor.
  • Place the headlamp switch in the AUTO position.
  • Turn ON the ignition, with the engine OFF.
  • Wait 20 seconds.

  • Do the headlamps illuminate?


    The next step is determined by a yes or no to this question.At this point gonna assume no.

  • Disconnect the ambient light sensor.
  • With a scan tool, observe the Ambient Light Sensor parameter.

  • Does the scan tool indicate greater than 3.76 volts?

    The yes or no answer here is a big one on moving on to where to go next.

    If yes
    Inspect for poor connections at the harness connector of the ambient light sensor.
    Did you find and correct the condition?

    If no
    Inspect for poor connections at the harness connector of the body control module (BCM).
    Did you find and correct the condition?


    At this point we will need the yes or no answers to determine whether it is a sensor issue or a bcm is issue will definiely need your input to determine which is causing your problem.

    2005 Chevrolet... | Answered on Mar 27, 2019


    If you go to www.car-part.com they have a built in Hollander interchange. Just punch in what you are needing and they will tell you what is available that fits. If you just keep track of what the engines are out of, you can figure out what interchanges.

    Chevrolet... | Answered on Mar 26, 2019


    Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you c an go there and try

    Chevrolet S 10... | Answered on Mar 26, 2019


    Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

    Chevrolet Cars &... | Answered on Mar 26, 2019


    Sounds like possible security light. Did you possibly get new keys?

    2009 Chevrolet... | Answered on Mar 26, 2019


    If you prime it and it runs till the prime is gone I would think it has something to do with fuel. The fuel pump could run but not put out enough pressure. I had a 88 blazer I was able to hook up a fuel pressure gauge by the left rear tire and found low pressure. I fixed the car when I changed the fuel pump. It could also be a fuel pump fuse or relay. If the pump is running it may rule out fuse or relay. Here are a bunch of video which has a good bit of info. Some of it may help. If you think it is a relay you may be able to swap relays with something else, if they are the same relay. Make sure what you swap with is not a vital part. I have found something like swap fuel with AC relay something like that. I actually went to a junk yard and found several relay for a dollar each one time. At that time I did not know anything about how to check them. They may not be a dollar now. Hope this helps
    https://www.youtube.com/watch?v=MO2cDvDwPp0
    https://www.youtube.com/watch?v=7syxAWw6Q-s
    https://www.youtube.com/watch?v=X1bdHQ0HbdA
    https://www.youtube.com/watch?v=pRWppSEogeo
    https://www.youtube.com/watch?v=HGdOwERGoe8
    https://www.youtube.com/watch?v=WdldGv40dS8





    Chevrolet Cars &... | Answered on Mar 26, 2019


    learn to drive. sell the vette

    Chevrolet... | Answered on Mar 25, 2019


    Behind the back right hand side of the glove box.

    Chevrolet Cars &... | Answered on Mar 25, 2019


    Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
    someone on fixya recommend ed it to me and I thank him even today
    They have full manuals and it's verrrrry cheap and mine
    I got free in offers

    Chevrolet Malibu... | Answered on Mar 25, 2019


    Are you sure they're supposed to? Should just be the DRL, or low beam headlights!

    Chevrolet Malibu... | Answered on Mar 24, 2019

    Not finding what you are looking for?

    Ask a Question

    Usually answered in minutes!

    Popular Products

    Top Chevrolet Experts

    Marvin
    Marvin

    Level 3 Expert

    84543 Answers

    Jonah Oneal

    Level 3 Expert

    14092 Answers

    Brad Brown

    Level 3 Expert

    18031 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...