Chevrolet Recent Questions, Troubleshooting Help & Support

Check fuse # 63 marked EPS, 80 amp. If that fuse is good, then you likely fried the Steering Control Module

Question edited for clarity and typos. Question moved to model category. Some idea in the link https://www.google.com/search?q=chevrolet+astro+won%27t+start+when+hot ..

fuse or broken wire

Question edited for clarity. Question moved from AC Cars, makers of the AC Cobra to model. Hundreds of them here! https://www.google.com/search?q=2006+Chevy+impala.+AC+compressor+bypass+pulley ..

Known issue. Get your battery on a charger. DON'T remove it from the vehicle. https://www.google.com/search?q=Chevy+Equinox.+It+beeps+5+times ..

Question edited for clarity and make some real sentences and punctuation. Change 'want' (a request for something) to 'won't' (a contraction of 'will not). So many Americans get this wrong! It is a Chevy, and it is 24 years old. When was it last serviced? Check spark plugs for gap and condition. Check compression. Also check transmission fluid level if by 'she won't move', you mean when you put the car into gear, it doesn't move. That could also indicate sticking transmission solenoids which free up as the engine oils and ATF get warm. ..

They are usually behind the centre console and glove box https://www.google.com/search?q=2006+Chevy+HHR+6%2C+2.4L.+replace+the+blend+door+actuator ..

Yes we have lots Pennylee, and also a Service Manual. https://www.google.com/search?q=vacuum+diagrams+on+a+1983+Chevy+p30+7.4 ..

These vehicles were known for faulty hazard switches. They would cause an intermittent turn signal flash when you hadn't activated turn signals or they would prevent the turn signals from working at all. Operate the hazard switch and see if the turn signals work again. If so, replace the hazard switch

This is an old thread, however here are some tips: Time to get strut nuts off: 2/3 days because I needed a really strong (impact) 22mm socket - 6 point and a 60cm breaker bar. Time tot get *** old wheel bearing out: 2/3 days because I needed bearing press kit and it takes about 100Kg of force to turn the 60cm breaker bar to squeeze out the old bearing and you better make 100% sure you have lined up the bearing pushing things and the thing that collects the bearing the other end. Project bearing installation is now starting ;)

The 2014 Chevrolet Malibu with the L4-2.5L engine does not have a 'typical' fuel pressure regulator. This vehicle has a fuel regulator valve (same function, just 'smarter' than a regulator). The pressure relief regulator valve replaces the typical fuel pressure regulator used on a mechanical returnless fuel system. Output drivers in the ECM provide the pump control circuit with a 12?V pulse-width modulated (PWM) signal, which regulates fuel pressure by closing and opening the control valve at specific times during pump strokes. On this vehicle, the regulator valve is built into and part of the high-pressure fuel pump. The high-pressure fuel pump is located on the rear, driver's side of the engine. For an image location view, click here: https://bit.ly/3mgrSAv. Before replacement, make sure to inspect the electrical connector and wire harness for any loose, broken or damaged wires. And the rubber lines for any cracks, holes or disconnections

Question edited for clarity and fix typo. Question moved to model category. 'Cranking' is purely the engine turning over. It cranks, almost starts and then it does nothing next time you turn the key? Flat battery. Or, you turn the key, it cranks, fires and almost starts and then dies? More reasons for that scenario. Check for diagnostic trouble codes. Did you disconnect the battery when you replaced the fuel pump? Did it work after that? Does it have an engine immobilizer and did you reset it after the disconnect? https://www.google.com/search?q=1999+Chevy+Blazer+crank+no+start ..

Question edited for clarity. Question moved to model category. There are 4.3 and 5.7 engine variations, but this say two ABS sensors and one transmission speed sensor. https://www.autozone.com/engine-management/vehicle-transmission-speed-sensor More and a video that may help https://www.google.com/search?q=2003+Chevy+Tahoe+2+wd.+How+many+speed+sensors ..

Question edited for clarity. Question moved to sub category. Shown in the link. It is in the engine bay. More on the images tab. https://www.google.com/search?q=2003+Chevy+Impala.+engine+control+module+location ..

Question edited for clarity. Question moved to model category. P300 is a random misfire in an unknown cylinder.

P0300 Code: What Causes It and Ways to Fix It!

way.com https://www.way.com > ... > Engine Codes The P0300 engine code indicates a misfiring cylinder problem in your vehicle. The misfiring happens when insufficient fuel is burned or when the spark plug gets ... ‎How much does it cost to fix... · ‎Can I fix the P0300 code myself? and P1021 is TPS issue. Start by cleaning the Throttle Body. What does code P0121 mean? The definition of the code means Throttle Position Sensor (TPS) "A" Circuit Range Performance Problem. Your car's TPS 'A' Circuit, like the TPS' B' Circuit, has an anticipated output voltage range (if so equipped).

P0121 Code: Causes, Symptoms and Ways to Fix It!

..

Is your check engine light on? Check engine light will disable the remote start feature.

I need a diagram for s10 rear brake lines 4x4 4.6 liter

https://my.prostreetonline.com/2016/02/10/how-to-test-a-chevy-silverado-o2-sensor/ This article will help you test the o2 sensor.