Champion Recent Questions, Troubleshooting Help & Support

The gap is 0.030 Pretty-much the gap for most of the motors in evinrude line-up during that era.

May need to have the field flashed. There are numerous videos on youtube showing you how to do this.

Depends on what year and model of engine you put it in.

This happened to me just now .. does anyone know the answer ?

clean over smoke,

If the starter drive is not removed from the start the engine will tent to drive the gear placing stress on the gear which will eventually wear off the gear.

The height is 4.75 inner diameter is 3 inches and outer diameter is 4.375.

Call for pricing 478 974-0018

Minimum pressure valve is defective and not allowing the air to flow through or oil air separator is bad which will also restrict the air to leave the separator tank.

3 inch pulley with a 3600 rpm motor. 6 inch pulley with 1800 rpm motor.

There is a couple of o-rings that could be bad. behind that cover is a centrifugal unloader that when the unit stops it reliefs all the pressure between the tank and the compressor head so the unit will not try to restart under a load.

Most pressure switches or 20 amp unless heavy duty. Do not recommend using pressure switch wired directly to motor 5 horse power are bigger.

Check the oil level, if oil level is ok, check the cooler for cleanliness, if cooler is clean, check the thermal valve by measuring the temperatures going in and coming out of valve. The final thing would be the air-end (pump). has lost it clearances.

The unit could have trash in the valve not allowing it to seat. Relief air and clean. If the unit blows air out for a couple of seconds after the unit shuts down that is normal. That is how the pneumatic valve works.