Casio Retail Supplies - Popular Questions, Answers, Tips & Manuals
IBM Toshiba SurePOS 4852-580 15 , cash register.
If an IBM Toshiba SurePOS 4852-580 15 cash register that you purchased used is not allowing you to make any changes and says "unauthorized," there could be a few possible causes:
- The cash register may be locked by a previous owner: The cash register may have been locked by the previous owner with a supervisor password. You will need to obtain the password to make changes.
- The software may be outdated: The software may be out of date and require an update. You will need to contact IBM for assistance with this.
- The system may have been tampered with: The cash register may have been tampered with, which could have caused the system to become locked and require a service technician to reset it.
- The cash register may have a security feature enabled: Some IBM Toshiba SurePOS have a security feature that allows only authorized users to make changes. You will need to contact IBM for assistance with this.
- The cash register may have an issue on the hardware: some issue on the hardware of the device could be preventing the device from functioning properly.
Have tried everything to get rid of E01 but nothing works ..!PCR-T290
You turned the key before you finished in another mode. The register is telling you to go back and finish what you started. For those of you with this problem, turn the key until you find a mode that doesn't give the error. This is the mode that you started working in but didn't finish. Now press subtotal. now press cash. You will have finished anything you started so now you can turn the key. you're welcome.
How to reboot
Hello,
I seem to recall there isn't really a reboot. If you are looking to change the system over to reflect your business and products a couple of tips are in store.
There is an internal battery and when it becomes weak it will cause a lot problems. I'd check the date on the internal battery and replace it if it is out of service life. Simply calling a local battery shop will usually get you a normal expectation for the life of the battery and also using your favorite search engine will find the same. The battery doesn't cost much but is very important to keeping your sanity.
Back to your reboot - I can say the best way to approach this register is to go through the manual which is located at the link below.
Best wishes,
Joe
http://totalpos.co.nz/wp-content/uploads/2012/10/Casio-QT6000.pdf I’m happy to help further over the phone at
https://www.6ya.com/expert/mark_7bbaa7a1174e0903
IPL fault, TE22000 how to troubleshoot?
Why were you trying to change the IPL? If you didn't have the new IPL and flashing software, you may have lost the firmware. Do you have the dealer IPL flashing software?
I can't sign in under my clerk ID!
Have you tried every other id? If so, you could try a flag clear (see the manual for procedure) which usually loads a clerk in order to allow programming while in program mode. Then you can edit clerk file again. Good luck
Not finding what you are looking for?