Casio Retail Supplies - Page 5 - Recent Questions, Troubleshooting & Support
Cash register casio tk 2300 not opening
If you can finish a sale but the drawer does not open, check the wires that come from the bottom of the register to the drawer. If one has broken or the plug has disconnected from the drawer, it will not open.
ERROR 026 ENTRE CONDIMENT PREPARACION PLU
First finish the sale currently being entered or cancel it. then turn key to program and press 3 subtotal, then press 0 and then the button which currently is requiring condiment entry then subtotal. turn key back to reg
Error e001
E001 error is the generic Wrong Mode error message on the Casio tills.
It simply means that a transaction was started in one mode without being finished before the key was turned to a different.
Return the key to the mode you were in before, complete the transaction then try turning the key.
If you keep getting the error turn the X and press SBTL.
Thanks,
Shopstuff
How to reboot
Hello,
I seem to recall there isn't really a reboot. If you are looking to change the system over to reflect your business and products a couple of tips are in store.
There is an internal battery and when it becomes weak it will cause a lot problems. I'd check the date on the internal battery and replace it if it is out of service life. Simply calling a local battery shop will usually get you a normal expectation for the life of the battery and also using your favorite search engine will find the same. The battery doesn't cost much but is very important to keeping your sanity.
Back to your reboot - I can say the best way to approach this register is to go through the manual which is located at the link below.
Best wishes,
Joe
http://totalpos.co.nz/wp-content/uploads/2012/10/Casio-QT6000.pdf I’m happy to help further over the phone at
https://www.6ya.com/expert/mark_7bbaa7a1174e0903
Application prob..
have you tried to remove the nokia software off your computer then re-installed that, then tried getting that application again?
IPL fault, TE22000 how to troubleshoot?
Why were you trying to change the IPL? If you didn't have the new IPL and flashing software, you may have lost the firmware. Do you have the dealer IPL flashing software?
Not finding what you are looking for?