Casio Cameras - Page 9 - Recent Questions, Troubleshooting & Support
Camera keeps resetting the settings when turned off
Possible solution?
PROCEDURE
1. Initialize the system.
a) Enter the TEST mode.
b) Select "3:ROM UPDATE" and press SET button.
c) Next, select "5:SYSTEM INITIAL" and press SET button.
d) The following message appears.
SYSTEM INITIALIZE
START ...
PUSH OK KEY?
e) Press SET button and System is initialized.
"SUCCESS !" appears on the monitor.
2. Write firmware.
Update the firmware version"
Write the firmware.
If the TEST mode boots automatically, change "USB TCC ON" to "USB TCC OFF".
How download firmware?
one. there is no firmware for the Z1200 to download, unless Casio says so.
two.
You can't put in other firmware in any device if it does not work perfect.
Updating a bad working apparatus by trying to change firmware is the only thing you should not try.
You will end with a device that can't be used for anything. Any defect will be pinter to as self induced.
This link will show you for what camera's Casio released updates of the firmware:
Digital Cameras Downloads Support CASIO
Card locked cant unlock
you have to take it apart the card has a switch on the side which bumps a pin insided the camera which grounds out the camera to lock it. You have to take it apart and pry that little tab out just a bit so no connection and it will work great. I just did it and no issues.
Casio Exilim Z57 Date and Language set up
OK, here's the fix. This camera has internal flash memory that is used to store settings and can be used for limited picture storage. Its use for saving setting is essential, however. If this gets corrupted then the camera won't save settings. Whoever said to format the internal memory had the right idea.
After much experimentation here's how. Remove your SD memory from the camera and turn it on. This will force it to run on the internal memory only. Run through the time/date/location setup again. It will complain about the memory card. Ignore this and press menu. Under Setup, select format. Choose format memory card and do it. This will format the internal memory. Once it is done, turn the camera off and back on. You'll notice that the problem is gone and it has remembered your last setup.
BTW, my camera is a EX-Z75. Not sure there is a Z57 model.
Screen casio 2097 2
This lcd screen display is for Sigma SD14, Casio EX-Z750, Casio EX-Z850, Fuji f10 and Ricoh r4 digital cameras.
Why the blitz is off n cant turn on or automatic again?
hello, has your camera hung up?
1. remove battery and put it in again
2. ensure that the battery is fully charged
3. in case the camera turns , do not do anything, just go to the set up menu and reset the camera , by pressing this camera switches off on it's own, and switches on again
4. with camera on give it a gentle whack with flat of your hand
hope it works
Not finding what you are looking for?