Cadillac Logo

Cadillac Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 410 Products
  • 123K Answers

You will have go to the Cadillac agent , purchase a new key and have them program it to the ignition switch.

Cadillac Cars &... | Answered on Feb 05, 2019

Should be on the throttle body...some vehicle you can replace the sensor and some you have to replace the throttle body.

Cadillac Cars &... | Answered on Feb 04, 2019

Connect obd reader and scan codes and clear them. If they go away you did that the first time you wrongly conected wires. If they don’t go away means that problem persists so recheck your job. Maybe they still not connected properly. If they are maybe you actually have problem with oil pressure and ac. Scan and read fault codes. That will help you diagnose it.

2007 Cadillac... | Answered on Feb 03, 2019

The dimming fuse supplies battery positive voltage to the license lamps, underhood lamp and to the dash integration module (DIM) park lamp input, for interior lamps dimming.
Dimming fuse 10 amp. under hood fuse box. the park lamp relay supply's battery power to that fuse .

2005 Cadillac... | Answered on Feb 03, 2019

W age of car..mounts probly worn as well as steerin parts . If shakes wile drivin then tires or balljoints bad..this can b dangerous..u can buy good used tires but b joints can collapse rite on interstate. Seek an old school mech and not a dealr

2001 Cadillac... | Answered on Feb 02, 2019

My Nissan civilian does not switch on I can't find main power supply fuse location

2007 Cadillac... | Answered on Feb 02, 2019

I think you mean a hard reset, first write down the radio presets then remove both battery cables then touch them together for at least 30 seconds then reconnect Positive cable First. I hope this helps, Take care.

Cadillac Cars &... | Answered on Feb 02, 2019

There is an electric motor that controls the blend door. You probably have an issue at the blend door. Either the motor is bad, or the actuator isn't connected. The actuator arms are know to crack and allow the motor to move without moving the actuator.

2006 Cadillac... | Answered on Feb 02, 2019

Shouldn't be hard, you need to take off the belt, need the special tool to take of or can make #15 mim. wrench or socket, remember how the belt is installed??? disconnect power from battery and wires from the alternator .look which bolts hold remove one by one.

Cadillac Cars &... | Answered on Feb 01, 2019

Did you ever find a solution to this? I am having the same issue on 2,4,6. I have replaced the coils. checked the intake for vacuum leaks. I am lost here let me know if you find anything and I will do the same.

2003 Cadillac... | Answered on Jan 31, 2019

if you have a visible chip on the key (resistor), the car may not be able to read the signal and go into fail safe mode.

Also try to unlock the car from the drivers door to see if there is an alarm issue. The disarm wire is attached to the key lock cylinder in the drivers door.

1993 Cadillac... | Answered on Jan 31, 2019

I got this free Pdf manual from an online store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the all the times I fixed the chipper in these 4 years

Cadillac Cars &... | Answered on Jan 30, 2019

Are you certain it is still getting fire once warmed up? Sounds like you might have a bad ignition module.

Cadillac Cars &... | Answered on Jan 29, 2019

sounds like quite likely your blower heater switch is the problem. Need to check out the blower heater switch and likely need to replace the switch.

Cadillac Cars &... | Answered on Jan 29, 2019

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cadillac Experts


Level 3 Expert

84027 Answers

Jonah Oneal

Level 3 Expert

14065 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14636 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides