Cadillac Vehicle Parts & Accessories - Recent Questions, Troubleshooting & Support
The cruise control on my
Sounds like you might have some corrosion at the contacts on the controller causing high resistance. If you are unsure where it is located, follow the cable from the throttle plate to the controller which will be black, and usually has a soft rubber cone shape on one end where the cable attaches. Pull the plug and inspect it for corrosion. You can clean the contacts with electronics spray or a mixture of baking soda and water. (1 tablespoon to 4 ounces of water). After the contacts are cleaned and free of any corrosion, rinse them thoroughly.
on Feb 02, 2018
How do I torque heads on a 1968 eldarado ?
Hi, You dont say which engine But 68 cads use 400+ cubic inch engines. It is the same as the 327.s. This is a very important procedure and MUST be done in stages and in a certain bolt tightening sequence You start at middle top and work your way around the pattern to just snug up the bolts. Then to 25 lbs following pattern Then 50 lbs Untal you reach your correct torque. DO NOT OVER TIGHTEN. You have to go on line (say Auto Zone site) and get the correct pattern and torque .
If you have installed new gaskets make sure they are installed correctly. should say this side up or right and left. If you don't find your spec's on line I can look them up in my goood old school books for you. Mike.
on Oct 12, 2014
Pc 0151 history
what year car is this! or if the check engine light is on. you can go to auto-zone etc, to have the code read for free of charge, just tell them your check engine light is on, and you need a readout of the code. good-day !
on Jan 14, 2012
Not finding what you are looking for?