Washing Machines - Page 6 - Recent Questions, Troubleshooting & Support


If the clothes are reasonably even at the spin cycle, then this is caused by worn out suspension rods,the out bowl is supported by 4 sprung rods, one on each corner you need to replace a set of four,if clothes keep all going to one side the replace the capacitor

Simpson Washing... | Answered on Jan 19, 2019


Too many suds. Probably used too much or wrong kind of detergent.

Washing Machines | Answered on Jan 19, 2019


the unit has a brake you cannot spin the drum in that way,with the back off there should be a lever with a cable on it pull the lever back and get someone to try the bowl then

Miele Washing... | Answered on Jan 19, 2019


Need help way am I'm getting e20 on my washing machine it only 3 month old

Washing Machines | Answered on Jan 19, 2019


Could be a number of things. Belt, control board, door lock, bearings.

Maytag Washing... | Answered on Jan 19, 2019


if its a top loader and the clothes are all twisted up then i sugest replacing the capacitor

Simpson Washing... | Answered on Jan 19, 2019


Hello there! PNC is 91460443901. 8kg washer & 6kg dryer.
E10 error means a problem with the water supply. Check water connections and drain hose of the rear side. Be sure that the water container fills after operation of the dryer. There is a small silicone / plastic tube on the back, maybe it needs cleaning...
Find below the link for the user manual of the machine, hope it will be helpful! Good luck!
https://www.manualslib.com/manual/458645/Zanussi-Zkn-7147-J.html
91460443901-ct1bjg4enodxolfgnsgwxivp-1-2.png

Zanussi Washing... | Answered on Jan 19, 2019


in most cases unplug from the wall for several minutes, and try again if that fails maybe a fault in the module

Beko Washing... | Answered on Jan 19, 2019


either the drain pump is blocked or jammed with something or the pump is faulty

Washing Machines | Answered on Jan 19, 2019


either something entered the wash on some dirty clothes or grease coming past the seal try a hot wash with plenty of suds and no clothes, a small wash level should do it

Washing Machines | Answered on Jan 19, 2019


brand and model please

Washing Machines | Answered on Jan 19, 2019


if a top loader check the drain pump to see if it blocked or faulty

Haier Washing... | Answered on Jan 19, 2019

Not finding what you are looking for?
Washing Machines Logo

255,129 questions posted

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Marvin
Marvin

Level 3 Expert

83850 Answers

Brad Brown

Level 3 Expert

17827 Answers

paul
paul

Level 3 Expert

825 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...