Vacuums - Page 7 - Answered Questions & Fixed Issues

The latch at the bottom of your vacuum cleaner. The problem is that 'React' seems to be a range of cleaners. Google make model (number) parts diagram https://www.google.com/search?q=Hoover+React ..

Your make and model number appears isn't stated and the category designation is incomplete. Find the model and look for a thermal protection fuse. https://www.searspartsdirect.com/combo/0247-1235880/craftsman-wet-dry-vacuum-parts ..

There are no schematics because you aren't supposed to take them apart. You can sent it back or just buy a new one. https://www.manualslib.com/manual/1739428/Craftsman-Easy-Fire-0993056.html#manual ..

Can be either
1hair, debris around the brush roller
2 brush roll bearings have hair Etc, right on them

3 brush roll bearings worn badly .
Do they turn freely, take out and turn while putting light pressure with fingers, light twisting

4 belt issue,
Did the belt before this one break or wear maybe too soon which points back to Roller/ bearings/ hair

https://everettvacuum.com/blog/check-your-brushroll-bearings

I am also looking for a replacement check valve for the S3501 shark steam mop. Can't find it anywhere online.

Hoover Troubleshooting Brush Not Spinning Changing The Belt On Your Dual...

gears may be stripped in the brush drive line. right off the motor is a gearbox, held on with two screws. getting to it is fairly complicated, fix is easy. parts can be found at Protech Robotics Parts and Service

Hello Shelley The loud whining sound could result from an obstruction within the various parts of the machine, like the noizzle or suction pathway.Check the motor could be having a problem

Full 'make model (what it is)' is needed in all questions on Fixya please. The drive belt is broken whether it is a standalone upright cleaner or whether it is a canister vacuum with a hose and wand with brush head. How you replace it is completely dependent on make and model, but can easily be Googled or refer to the manual.

It appears for have hidden spindles holding the wheels so would involve full disassembly. No one has documented this before https://www.nilfisk.com/global/consumer/products/vacuum-cleaners/traditional/elite-energy-comfort-eu/c_107413385/ By the looks of it, you start with the 2 screws in the bag access bay and then keep going. This is a job that should be done by a service centre. https://www.google.com/search?q=Nilfisk+Elite+Comfort+disassembly The Parts Diagram shows all the relative parts and the wheels are held internally by one screw. Blow the PDF image up to 250%. https://www.wap-nilfisk-alto-shop.de/media/pdf/83/5d/da/ET_Elite.pdf ..

You have a blockage somewhere either in the hose, or in the unit. https://www.google.com/search?q=eureka+airspeed+blockages ..

I would try www.espares.com

Possible electrical short in the reset switch.

There is a trigger/sensor that activates when a new bag is replaced. Check to see that it is not stuck or dirty and moves freely when touched.

Check for dirt in tracks of closure mechanism, clean as nessary. Also, check worn mis-aligned, adjusted clasp.

Hold the unit aloft, then tap lightly with a rubber or wood mallet all the way around the filter housing, try turning it then repeat process, it should come off eventually.

you will to take motor to motor shop, disassemble motor and take bearing shop, OR buy a new motor for less money copy and paste link https://evacuumstore.com/p-9980-sanitaire-commercial-upright-sc679-j-motor-assembly.aspx

Sounds like an unwanted ingress of water into the motor assembly. Not a lot can be done without stripping the machine down and taking a look at any damage.