Saws - Page 8 - Answered Questions & Fixed Issues

Grease and oil flow down hill. Check the bottom wheel .If you see any sign of lubricant at center of wheel ,you may have to change a seal at that area. GOOD LUCK FRIEND.

Possible throw out bearing or pilot shaft bushing.

I would suggest calling Hilti direct at 1-800-879-8000 and speak with their tech department and they will be able to assist you in locating parts and your mfr question

normal thread right hand thread

have you checked voltage to saw, perhaps the power switch is bad, perhaps the gfci receptacle tripped.

Hi, please check your local home depot or lowers for the part. You can call them or search their website for the product. Thank you.

Hi, In this case, it might be best to reach out to the manufacturer in order to get find the safe and most affordable replacement for your bandsaw. If you don't want to use that route, please reach out to your local Home Depot store via phone to have them check their catalog of products for your gear. Thank you.

Hi, please look for the tool on ebay or call lowes and home depot to ask them to search their databases for the tool. If all else fails, you might have to look at buying from Alibaba as it has an international reach. Thank you.

limited info generic answer check tesioner refer to your manual on adjustment

There is a button on the saw that holds the shaft still. Unplug the saw and put light pressure on this button while you slowly turn thr blade by hand. When it gets to the hole, the button will drop into the shaft. Keep it pressed down and unbolt the nut.

Greetings from Toronto - ish. I am in Canada so my searches are normally weighted to Canadian suppliers. In this case none are .ca However Repair Clinic do supply to Canada and have a 1-800 number that states it on the Contact page. https://www.google.com/search?q=terratek+sliding+mitre+saw+parts ..

the belt shape new will not effect replacing it. It does not stretch but slides on. Did you loosen screw? Refer to instructions page 19-20. Tey calling the number listed in instructions. https://www.manualsdir.com/manuals/79545/elektra-beckum-kgs-303.html?page=19 ..

Question moved from Bosch Computer, to Bosch 4000 table saw. Unplug the unit and turn the blade by hand. Check the blade is tight and running true. See if the blade is touching anything. If you can't see anything wrong there, it make be the carbon brushes in the motor.

The links in here says there is. https://www.google.com/search?q=Model+3320445+compressor+reset ..

Can you get a compression tester to check the compression? With the throttle wide open, the choke OFF, and the decompression valve (if so equipped) NOT engage, pull the engine over 3-5 times or until the gauge quits rising. You would like to see 90psi or more and if it is at 60 or less then it is most likely a scored piston and cylinder or bad rings. If the compression is good you need to check for spark. If it has good spark then it will most likely be fuel related. Often a complete tear down and rebuild of the carb is what is required.

First thing I would check are the Carbon Brushes. The are # 75 in the picture



Hope this answers all your questions
Please remember to Rate/vote for any solution that helps you out.
Thanks for using Fixya.

They are a reliable saw. Presumably you are replacing the piston and rings and honing the bore. Strip and clean the carburetor. Replace the spark plug and lead. https://www.google.com/search?q=MAKITA+7301+SAW+full+service ..

Parts suppliers https://www.google.com/search?q=terratek+12%22+sliding+compound+miter+saw+parts ..

Thanks your question. please see this video