Saws - Page 3 - Popular Questions, Answers, Tips & Manuals
R18CSP circular saw spares
no ------fixya doesnt sell products and doesnt have stores fixya is an online repair forum
6/7/2023 10:16:07 PM •
Saws
•
30 views • 0 helpful votes
Mastercraft mitre saw arm will not lift
drove my mitre saw to the levee but the levee was dry
this old boy drinking whiskey and rye. sing'n....(american pie)
gotta see that act, can I do a youtube of yah?
Saw stops after 10 seconds?
All questions need FULL 'make model (what it is)', or they are impossible to answer.
Have you tried asking the maker? This sounds like a commercial quality automated saw.
4/6/2023 2:10:26 PM •
Saws
•
62 views • 0 helpful votes
My Hitachi C10FS compound miter saw runs very unsteady. Power cuts in and out constantly. I just changed the switch and installed new brushes I
If your Hitachi C10FS compound miter saw is running unsteadily and the power cuts in and out constantly even after installing a new switch and brushes, there may be a few possible reasons for this issue:
Loose or damaged connections: Check all the electrical connections in the saw to ensure that they are properly connected and not damaged. Loose or damaged connections can cause intermittent power cuts.
Faulty power cord: The power cord could be damaged or have a loose connection, which can cause the power to cut in and out. Inspect the power cord carefully, and if necessary, replace it with a new one.
Faulty motor: If the motor is faulty or damaged, it can cause the power to cut in and out. You may need to have the motor repaired or replaced.
Electrical interference: If the saw is being used in an environment with high levels of electrical interference, this can cause the power to cut in and out. Try moving the saw to a different location to see if this resolves the issue.
If you have checked all of these potential issues and the problem persists, it may be best to take your saw to a professional for further diagnosis and repair.
3/11/2023 9:37:43 PM •
Hitachi Saws
•
115 views • 0 helpful votes
My 12" Milwaukee Miter saw is making a noise when braking?
Screeching is always caused by dry metal on metal. It need oil on anything that spins or slides. See if the brake actually has fibre pads like the disc brakes on your vehicle.
Google
make model parts diagram
All questions here need full make and model number, plus '(what it is)'. You got 2 of 3 :>D
Not finding what you are looking for?