Roofing - Answered Questions & Fixed Issues


get a ladder, climb up there, reach in, and pull them out. you probably will want some gloves. or pay the little kid in your neighborhood 20$ to do it

Roofing | Answered on Mar 19, 2019 | 1,187 views


water will only run downhill someone will have to rehang them so that the drain is lower than the rest of it

Roofing | Answered on Dec 21, 2018 | 1,281 views


Try a roofer in your area of the world.
When asking a question like this on the World-Wide Web, you need to be a little more specific. I could suggest the contractor who recently did my roof and gutters, but I doubt you'd want to pay to have them come from where I am to where you are.

Roofing | Answered on Nov 14, 2018 | 1,385 views


A slate roofing is actually a nice idea because its make your home quite pretty. To use slate roofing first you need better kins of slates its breakable also but now including roofing you should try another options like metal roofing, rolled roofing , its easy then slate roofing you can also visit http://andersonindustrialroofing.net/replacement/

Roofing | Answered on Feb 14, 2019 | 1,627 views


As the name suggests it is entirely flat with a slight pitch to allow water run-off. It is useful to install in places having low or high rainfall. They are also conducive for PV solar panels, simple to construct and cost-effective. However, they are usually susceptible to water leakage. The flat roof might not be the best at getting rid of rain and debris, but in a warmer climate where storms are more unlikely, they can be very good shaped roofs. The flat roof is very easy to build and very cost-effective. They are also very good at keeping the heat from the sun out of homes and buildings. Visit this website to know more about roofing.
Materials suggested for use include; metal sheets, rubber membrane, grave and tar, TPO and others.

Behm Design 20 x... | Answered on Aug 20, 2018 | 1,010 views


You should call an ingenior to come and take a look at your roof , it will cost you a bit of money , but if he can state that your roof need to be redone again you should easily get a clean case in court

Roofing | Answered on Jul 18, 2018 | 1,847 views


first not to do is
not to fall off the roof--it really hurts
next
not to wear any foot wear that slips when the roof is wet or you will falloff
don't work close to the edge
If the roof is more than 5 degrees slope , you will need safety harness and restraint to stop you sliding off the roof

Roofing | Answered on Jun 26, 2018 | 313 views


There are many variables to consider such as Location and House Height but below is a good estimate.

Aluminum: $5-$8 per foot (I live in Midwest and have a guy that will do it for $2 a foot)
Copper: $15-$25 per foot
Vinyl: $3-5 per foot
Steel: $8-$10 per foot

Roofing | Answered on Jun 06, 2018 | 956 views


https://www.cunninghamcampers.com/fckimages/pdf/jayco-owner-manuals/1999CTEagle.pdf

As far as I can tell there is just a general owners manual for all 1999 jayco eagle fold downs. Above is a link to that.

Roofing | Answered on Jun 06, 2018 | 817 views


yes but to get a professional job , check you local registrar of professional roofers
may save you getting ripped off

Roofing | Answered on Nov 27, 2018 | 342 views


start at opposite end of the drain pipe / 2 % slope down this will prevent water build up

Roofing | Answered on Mar 31, 2018 | 377 views


Hello, Jose -

I am not a gutter intaller. However, from high school chemistry class I recall that when aluminum is in contact with copper, corrosion will occur.

Best wishes.

Roofing | Answered on Mar 13, 2018 | 384 views


If you are looking for roof repair services then BP Roofing could be best solution for you. Welcome to BP Roofing Best Roofers Auckland

Roofing | Answered on Sep 18, 2018 | 1,737 views


If you can't see where the leak is coming from exactly you can start from where you think the leak is and lift the roof shingles if its the right place you will start to find mold under them and that's where you should start fixing the roof.

Roofing | Answered on Nov 12, 2017 | 2,309 views


Glycolysis breaks down glucose and forms pyruvate with the production of two molecules of ATP. The pyruvate end product of glycolysis can be used in either anaerobic respiration if no oxygen is available or in aerobic respiration via the TCA cycle which yields much more usable energy for the cell.
Glycolysis Wikipedia

Roofing | Answered on Jul 05, 2017 | 1,113 views


Aluminum

Roofing | Answered on Jul 05, 2017 | 788 views


Remove the vinyl siding and tear off the flashing and put down new.. use short roofing nails

Roofing | Answered on Jul 05, 2017 | 1,121 views

Not finding what you are looking for?
Roofing Logo

Ask a Question

Usually answered in minutes!

Top Roofing Experts

Marvin
Marvin

Level 3 Expert

84581 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Roofing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...