Pool & Spa - Popular Questions, Answers, Tips & Manuals


Test other safety devices for continuity...flow switch, thermocouple, and flameout.

Pool & Spa | 50 views | 0 helpful votes


My EasyTouch was set to "Man. Heat>ON". Once I turned that off, it worked from ScreenLogic.

Pentair Pool &... | 119 views | 1 helpful votes


turn off then back on after 3 unsuccessful cycles will lock out check see if gas on if ok check ignitor

Pool & Spa | 34 views | 0 helpful votes


The fuse link is a device that will open when over heated. If the exhaust temp is to high it will open and is a one time device. It can not be reset it must be replaced with a high temp fuse link made for the exhaust location. It will have a red mark on it indicating high temp.
Low gas pressure can cause a lean fuel condition that may cause the exhaust temp to rise enough to trip the link. I would also check for scale inside the heat exchanger. Scale inside the heat exchanger will not allow for proper heat transfer to the water, this will cause excess heat to be present in the exhaust. Proper water balance and flow are very important.

Jandy Pool & Spa | 41 views | 0 helpful votes


I recommend a sand filter system. It is much easier and cost effective than paper filters. Second watch your water PH levels.

https://www.splashpoolsupply.com/FAQ_Splash_Pool_Supply_s/102.htm

Intex Pool & Spa | 26 views | 0 helpful votes


use bike tube repair glue but let all the air out first

Intex Pool & Spa | 31 views | 0 helpful votes


there's a website reliable-store
all heavy equipment repair issu es servicing, loading, wiring, engine problems everything is covered here its a must try

Pool & Spa | 22 views | 0 helpful votes


Always be careful when when working on pool filter electrical issues. It's important to make sure the power is off before proceeding and get help from a trusted professional if you're struggling to resolve the issue.

Aqualogic Pool &... | 29 views | 0 helpful votes


You don't list you specific model so I can only give you a general answer.

Try the below link.https://www.intexdevelopment.com/support/12025/productdetail

Hope this helps you out. J

delete-brcr54jbzk5xor1hc20y04z0-2-1.jpg

Intex Pool & Spa | 63 views | 0 helpful votes


I found this
I found an R5350ti-E owner's manual but it does not list the FS2 error code. It does show an FS error code that explains it is code for the heat pump's defrost cycle. The fan will spin but the compressor is shut off.

https://www.google.com/search?q=Turbotemp+Gas+Pool+Heater+has+error+code+52

Pool & Spa | 25 views | 0 helpful votes

Not finding what you are looking for?
Pool & Spa Logo

27,154 questions posted

Ask a Question

Usually answered in minutes!

Top Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1389 Answers

Bill Jordan

Level 2 Expert

373 Answers

David Spradling
David Spradling

Level 3 Expert

9859 Answers

Are you a Pool and Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...