Locks & Locksmithing - Page 2 - Answered Questions & Fixed Issues
Kwikset smartcode lock blinking red keypad
Another cause for the red LED blinking on your Kwikset lock, especially when it beeps 3 times is it could be jammed or misaligned. When this happens, check and see if the door is securely latched or aligned properly. If needed, you can also adjust the strike plate to get the latch moving freely again.
You can read more here: https://revolar.com/why-is-my-kwikset-lock-blinking-red/
6/17/2023 4:03:43 AM •
Kwikset 909 ...
•
Answered
on Jun 17, 2023
•
8,996 views
Suresafe Digital Safe misplaced key
Well you put the code in and it opens.
I guess you missed of the part where you ignored the 'Change Battery' notifications and the incessant beeping :>D Or has it just failed, found it in a skip, found it in a house, code written on the back?
You can open it faster with a rare earth puck magnet than you can inputting the code. The word ;Safe; is a misnomer.
5/31/2023 2:53:18 AM •
Locks &...
•
Answered
on May 31, 2023
•
49 views
Onity ht 24 lock. master key will work. room key flashes red/green. i reprogrammed lock and have same issue
If the master key works on your Onity HT24 lock, but the room key flashes red/green, it may be a problem with the key itself or the lock cylinder. Here are some steps you can take to troubleshoot the issue:
- Check the battery: Make sure the battery in the lock is fresh and has enough power to operate the lock. A low battery can cause the lock to malfunction.
- Check the key: Inspect the room key for any signs of damage or wear. If the key is damaged, it may not work properly and will need to be replaced.
- Check the lock cylinder: If the key is in good condition, it may be a problem with the lock cylinder. Make sure the cylinder is clean and free from debris. If it is dirty or has debris inside, it may need to be cleaned or replaced.
- Reset the lock: Try resetting the lock by unplugging it and removing the batteries. Wait a few minutes and then reconnect the power and batteries. This may help to clear any errors and allow the lock to function properly.
- Contact the manufacturer: If none of these steps resolves the issue, you may need to contact the manufacturer for further assistance. They may be able to help diagnose and fix the problem or recommend a professional locksmith who can assist you.
3/18/2023 7:48:47 PM •
Locks &...
•
Answered
on Mar 18, 2023
•
1,389 views
How do we adjust an aluminium door?
the door has a cam that has to be adjusted to force the pin up
call a local glass company and ask them where the adjustment is located
there is usually some type of access plat near the bottom of the door frame close to the hingee on the inside close to the bottom
2/8/2023 6:35:41 AM •
Locks &...
•
Answered
on Feb 08, 2023
•
990 views
How do I reset REI Double cable lock
- Locate the reset button, which is usually a small button or lever located near the combination dials.
- Press and hold the reset button while turning the dials to set your new combination. Make sure to remember this new combination!
- Release the reset button and test the new combination to make sure it works.
Please note that the specific location and method for resetting the combination may vary depending on the specific model of REI Double Cable Lock you have.
1/20/2023 10:02:21 AM •
Locks &...
•
Answered
on Jan 20, 2023
•
195 views
My delsey combo lock won't lock?
If your Delsey combo lock won't lock, there are a few things you can try to troubleshoot the issue:
- Check the battery: Make sure the battery in the lock is not dead. If the battery is low, replace it with a new one.
- Check the lock's alignment: Make sure that the lock is properly aligned with the suitcase zipper. Sometimes the lock may be slightly off-center, which can prevent it from locking properly.
- Check the lock's mechanism: Make sure that the lock's mechanism is not jammed or damaged. If it is, it may need to be repaired or replaced.
- Check the lock's code: Make sure you have entered the correct code for the lock. If you have forgotten the code, you may need to reset the lock or contact the manufacturer for assistance.
- Clean the lock: Sometimes dirt and debris can accumulate in the lock mechanism, preventing it from functioning properly. Clean the lock with a soft cloth and mild soap.
- Check the suitcase: Make sure the suitcase is not damaged in any way that can prevent the lock from closing properly.
If none of these solutions work, it may be best to contact Delsey customer service for further assistance. They may be able to provide additional troubleshooting steps or may suggest to get the lock serviced.
3/18/2023 7:51:59 PM •
Locks &...
•
Answered
on Mar 18, 2023
•
274 views
How to open my kingavon safe 28 without key. Cannot open with code either
I have the Kinavon 28 safe, I have lost the keys and the batteries started to die, eventually the batteries I think have given up, I use to get all the three lights on, red, yellow green but now I'm only getting the yellow light on, there's no clicking as It usually did, has anyone any Ideas how I can access It or resolve this problem?
3/18/2023 7:52:41 PM •
Locks &...
•
Answered
on Mar 18, 2023
•
1,306 views
Not finding what you are looking for?