Cooktops - Page 6 - Answered Questions & Fixed Issues
My candy ceramic hob alternating flicking F and H? What's wrong?
The 'H' symbols will flash in the display the first time your hob is connected and switched on. This is because the hob has been heat tested at the factory, then switched off while still hot. This may also happen if you are using the hob and you have a power cut.
Error code F1 indicates that the power is too low due to unsuitable cookware or an empty pot. Error code F indicates that there is no cookware on the zone or the cookware is unsuitable.
..
10/4/2021 8:53:15 PM •
Candy Cooktops
•
Answered
on Oct 04, 2021
•
2,239 views
GE Cooktop drop-in model # jgp328bec2bb - how to
Turn off the gas,unplug the power.
Take the cooktop out of the cutout and support it on the countertop.
Remove all grates and valve knobs.
Remove all screws from the valves and the burners.
Remove the burner base plates.
You may have screw on the side holding the top to the base,if so,remove these too.
The top will separate from the bottom exposing your parts.
We can not turn on stays locked ;we have an Miele induction cook top
https://www.coolblue.nl/en/advice/errors-miele-induction-cooktops.html
How do I unlock
my Miele cooktop
? Just under the lock light you should be able to press/hold with your thumb for about 5-15 seconds and it should reset. You may need to place your thumb directly over the lock light or just below it and hold it for that time.
Just under the lock light you should be able to press/hold with your thumb for about 5-15 seconds and it should reset. You may need to place your thumb directly over the lock light or just below it and hold it for that time. If this doesn't unlock when you do this then you have a problem with the control board.
11/17/2021 11:18:00 AM •
Miele Cooktops
•
Answered
on Nov 17, 2021
•
5,363 views
I Bought Prestige induction stove
E5 or E0 means that the stove is getting overheated. You have to reduce the temperature for it to stop. It goes on with few beeps and then stops.
7/18/2021 7:13:15 PM •
AEG 23 in....
•
Answered
on Jul 18, 2021
•
4,134 views
Not finding what you are looking for?