Humidifiers - Page 5 - Answered Questions & Fixed Issues
I purchased a home with
Here is a link to the owners manual. http://www.aprilaire.com/themes/aa/en/manuals/Humidifiers_Owners_Manual.pdf
You can also pickup some cheap humidity gauges at a hardware store to check the settings on your unit verses the actual humidity in the house.
11/4/2021 12:33:48 PM •
Aprilaire...
•
Answered
on Nov 04, 2021
•
234 views
Our house is extremely humid and the a/c needs to
Hello
It depends on personal preferance,an air conditionner is going to remove humidity or water from the home,as water contains heat.
I would shut off the humidifier.The 40% setting depends on where in the world your located,say nevada is dry and hot so you may want a humidifier.Where florida is hot and humid so you would want to dehumidify or get rid of the humidity.
Lower the setting to 20% or just turn it off.
Fridgidair humidifier not humidifying.
A 'humidifier' puts moisture into the air. A' DEhumidifier' take water OUT of the air. It depends on what you have.
Make and model is needed in all questions on Fixya please.
As an aside, my room is 37%.
11/4/2021 12:12:44 PM •
Humidifiers
•
Answered
on Nov 04, 2021
•
154 views
What buttons do i push to fix resmed s9 error: settings reset to default values
I fixed my machine with this error by doing the following.
You need a T8 torx screwdriver and a thin flat blade srewdriver plus a replacement CR2032 button cell. Ensure that the S9 is disconnected from its power adapter. First pry up on the setting rotary knob at the top of the S9 and remove. Next remove the T8 torx screw from the bottom corner of the machine. There are then four slots located on two of the sides. Insert the flat blade screwdriver into one of the slots and gently push inward to unlatch that finger while also lifting/prying up the bottom cover. You should then be able to work your way around to each of the fingers and lift the bottom cover off. This then exposes the circuit board. There are two more T8 torx screws holding the circuit board in place. Remove them and carefully lift the board slightly. You can then see the button cell in it's holder at the corner which can now be removed and replaced with the new CR2032. The S9 can now be reassembled in the reverse order. Once reassembled, connect the power adapter but do not power on yet or you'll get the same error message as before. Hold down the power button and then while still holding it down power up the machine. Good luck, hope this helps.
8/11/2021 5:38:16 AM •
ResMed S9...
•
Answered
on Aug 11, 2021
•
3,243 views
I need a kaz steam
How many watts does
Kaz Steam Vaporizer Safeguard Model 76 use???? I think it's using a lot of electricity. Anyone with clarity please?
6/22/2021 12:43:48 PM •
Kaz Humidifiers
•
Answered
on Jun 22, 2021
•
2,341 views
How to make the orange light go off
The Main reason why it comes on is the water is empty. Beyond that.. try cleaning your machine. Also, I have two of these thing and I have yet to get it to work more than five minutes on high. Low.. it works all day long.
Not finding what you are looking for?