Hand Tools - Page 4 - Popular Questions, Answers, Tips & Manuals

I don't think so, It did that on one of my lawn tractor batteries but not on the other lawn tractor or car battery, I suspect something is wrong with the battery.

Yes you can, its also really easy because they don't have to be super sharp. Dave Jeske Sharpens Marking Knife

It shouldn't be too sharp because if it is then it will cut into your project and can actaully make it more difficult to use.

The best thing to use is contact cement or super 77 spray adhesive. Put either one on both surfaces, let dry, set it back on and use painters tape to hold on for 24 hrs.

The first known manhole covers that have been found date back to ancient Rome, where stone sewer-grates were used.

Manhole covers are usually made from cast iron and so they are pretty heavy. They can weigh anywhere from 85 to 300 pounds.

are not replaceable throw it away

take a small brush like one you would use to clean a gun. clean it well and use gun oil to lube it

Put a little gun oil on the staples the spring that helps feed them might be catching

Blade is in upside down.

with regards to the stanley power stapler gun............replace the micro switch

Try Amazon for buying wire and cable tools online: http://www.amazon.com/s/ref=nb_sb_noss?url=search-alias%3Daps&field-keywords=Wire%20%26%20Cable%20Tools

E-bay.

Buy a set that has metric and SAE.

I got a good one on e-bay, now I have lots of bits!

Most any hardware store.

get a rubber pad at Tractor supply that they use for horses - cut it about 3" wider on all 4 sides and put under it - that should solve it.

The best way to know for sure is to try it - it may be dependent upon your choice of detergent and the chemistry of your water.

I found a 1200mah 3.6v NiCd pack at BatterySpace.com for $10.99 each, the lowest shipping cost was FedEx Ground at $13.04 so I bought three of them, I'm sure I know some others that will need the other two. The quote 5 days to ship, in case they need to assemble them from individual cells. The only issue is that I probably will have to modify the tabs to match the wiring in the scissors body, I'm sure Mr Dremel will come through for me on this point. Black and Decker is most certainly *not* the best place to look, they have an exploded-view diagram of the scissors but have discontinued all parts for this model. Van

Either the pressure release valve is loose or the seals are worn out. Make sure the screw valve is tight. If that doesn't fix the problem, buy another jack. The seals really aren't user replaceable.