Grilling - Page 5 - Popular Questions, Answers, Tips & Manuals
I put a new burner assembly, I have the same problem. The first of three plaques won't light correctly.
In the past I have owned several portable gas room heaters of a similar design and I remember needing to blow gently across the unlighted radiant of two of them before it would light.
I am not absolutely certain but I seem to remember the centre radiant of the heater that worked well was slightly different in that at each bottom corner there was a slightly bigger hole that allowed a little tongue of flame to emerge at an angle so when 2 or 3 radiants was selected they lit without hesitation.
12/18/2020 10:51:01 PM •
Grilling
•
57 views • 0 helpful votes
My grill is not getting gas and has a new tank
First, check and inspect the tank's propane level to make sure that the tank has gas. Next, reset the pressure regulator to restore gas flow through the regulator if the regulator's flow limiting device tripped. Replace the pressure regulator if it does not allow the gas to flow to the manifold after resetting the flow-limiting device.
8/13/2020 8:23:43 PM •
Grilling
•
263 views • 0 helpful votes
How to clean Venturi tubes on blue ember grill
Use aventuri brush to clean the venturi tubes.special care should be taken to make sure the brush passes through any curve in the venturi tube. You may also flush out the tubes with a strong flow of water from a garden hose
9/23/2020 11:09:37 PM •
Blue Ember...
•
79 views • 0 helpful votes
Not finding what you are looking for?