Fish - Page 9 - Popular Questions, Answers, Tips & Manuals
Master flow mf-1040 pressure guage inoperative
This is an air compressor not for fish, take the gauge off and see if there is a blockage. Run the compressor without the gauge and see if you feel air coming out of the hole where the gauge goes. If you do then the gauge is bad and it will need to be replaced. Masterflow should be a company online contact them for a replacement.
What do cheeatahs eat
The cheetah is a carnivore, eating mostly mammals under 40 kg (88 lb), including the Thomson's gazelle, the Grant's gazelle, the springbok and the impala. The young of larger mammals such as wildebeests and zebras are taken at times, and adults too, when cheetahs hunt in groups. Guineafowl and hares are also prey.
12/4/2013 1:28:19 AM •
Fish
•
527 views • 2 helpful votes
I cant find a filter anywhere for a resun aquastar filter
i have the same tank i take of the plastic cover that holds the filter take the 3 sponges and get the water from the tank and wash it in that and through that water away thats what i do but i dont use it anymore i used it for breeding my whitecloud mountain minnow
12/4/2013 7:52:39 PM •
Fish
•
458 views • 0 helpful votes
Light Voltage
take a multimeter and measure for 5 volts, red is positive
and black is negative this should be coming from a 12 volt dc power supply current should be millivolt range , the voltage dictates the heat and brightnss of the leds. if unsure goole type manufacture numbers for specs.
12/14/2013 11:05:55 PM •
Marineland...
•
320 views • 0 helpful votes
Steering rattle on a 2007 Chevy Cobalt
1st place to look is sway bar links (one on each side). For some reason, the passenger side link arm bushing wear out faster. If you can find any slack whatsoever by twisting... then you found the problem. Always replace both sides at the same time, and then get a front end alignment. Did my 2006 Cobalt for $35 plus alignment!
My pump has been acting up for a while now. I turn
Hi Valerie,Here are some causes and solutions to your issue:1) Unit Not Plugged In
- Make sure the unit is plugged into a 3-wire grounded outlet.
2) GFCI Breaker Tripped
- If GFCI breaker trips, reset the breaker. If problem persists, have an electrician check the circuit.
3) Low Voltage
- Check the line voltage and make sure it is 105 to 125 AC volts.
4) Rotor Jammed
- See the "Rotor Service" diagram in the assembly view of the Filter/Pump unit of page #3 of the Manual
The manual can be found here:
http://www.backyardocean.com/v/pdf/SFS-Filter-System-Manual-2011.pdfIf you are still having issues, please email me at
[email protected] and I would be glad to help you further.Best Regards,Sasha
Phones keep blinking on DECT 6.0
What model DECT 6.0 phone?What's blinking? The entire display or just the message light? If it's the message light then you have unheard messages on the voicemail system provided by your telephone company. This system records messages when someone calls while you're already on the phone. Please contact your telephone company for instructions on accessing their voicemail system.
10/17/2013 12:47:09 AM •
Fish
•
366 views • 0 helpful votes
Not finding what you are looking for?