Electrical Supplies - Page 3 - Popular Questions, Answers, Tips & Manuals
What is the colored wire positions on a craftsman 2400 mower key switch
See following URL for complete wiring diagram.https://www.searspartsdirect.com/model/3x23oa7iyt-000247/craftsman-917203831-front-engine-lawn-tractor-partsSwitch Terminal to circuit color.B RedS WhiteM Black (Black/white)A1 BlueA2 BlackL BlackG BlackUnfortunately 4 of the circuits are not uniquely color coded. If the black wires have been disconnected from the switch socket then it will be necessary to identify each black wire to its respective circuit.
9/28/2023 5:02:03 PM •
Craftsman...
•
44 views • 0 helpful votes
I need a replacement thermostat for my Robertshaw 9420, will a Robertshaw 9560 be a close replacement?
Replacing a thermostat with a different model requires careful consideration of compatibility, wiring, and features. To determine if a Robertshaw 9560 can replace a 9420:
- Verify compatibility with your HVAC system based on manuals.
- Check wiring compatibility or consult an HVAC technician.
- Compare features to meet your heating/cooling needs.
- Ensure programming aligns with your requirements.
- Confirm power requirements match your setup.
- Assess the user-friendly interface.
- Check thermostat size and mounting options.
- Prefer professional installation if unsure.
- Investigate warranty and support for the 9560.
I have a Yamaha Ef2600 fw generator that starts and produces voltage and current but also gives out a 'clunking' noise on a 2 - 4 second cycle. What is wrong with it?
Based on the search results there are a explanations, for the clunking noise in your Yamaha EF2600FW generator;
1. Load handling; One potential reason could be that the generator is facing difficulties in managing the load, which could be due to fuel or air supply. This can result in the generator producing a clunking noise.
2. Fuel shortage; Another possible cause might be a lack of fuel supply to the generator leading to a knocking sound. It is advisable to address this fuel issue before operating the generator to prevent any damage.
3. Storage conditions; The clunking noise could also arise from storage conditions. Over time certain components like piston slap or dry rod bearings may develop problems resulting in sounds when the generator is running.
To diagnose and resolve the problem with your generator it is recommended that you take the steps;
Check and ensure a fuel supply. If needed, clean or replace the carburetor.
Inspect the generator thoroughly for any signs of damage or wear in areas like piston and rod bearings.
These actions should help. Rectify any issues causing the clunking noise, in your Yamaha EF2600FW generator.
If the problem continues you might need to reach out to a technician or get in touch, with Yamaha customer support for help. Always prioritize safety when dealing with generators or any other equipment. If you feel uncertain or uncomfortable about troubleshooting or making repairs yourself it's best to seek assistance, from a professional.
8/25/2023 10:38:59 AM •
Yamaha...
•
63 views • 0 helpful votes
Powerhouse 3100RI has no spark, plug has been changed. Where to look and what to check
It has low oil level cut off which will prevent spark. Check there is sufficient oil in the engine crankcase. Oil level alert sensors are a common failure so if there's sufficient oil then disconnect the sensor. If engine then runs, replace oil alert sensor.
Owners manual is available, no fee download, at the following URL.
https://www.manualslib.com/manual/722234/Powerhouse-Ph3100ri.html#manual
7/26/2023 9:00:26 PM •
Electrical...
•
65 views • 0 helpful votes
Not finding what you are looking for?