Camping, Backpacking & Hiking - Popular Questions, Answers, Tips & Manuals
How do i change bulb in garrity led light
Had a look on their web site and couldnt find that torch in their product lists. Basically with all LED lights the LED is soldered onto a small circuit board and is not generally replaceable unless you are into electronics and can solder in a new led.
Garrity Led Rch...
56 views | 0 helpful votes
My flashlight won't charge but still turns on when plugged in
Hello, Jacob -
I am guessing that your flashlight uses a rechargeable battery or batteries. If so . . . if you have not already done so, have you replaced the rechargeable battery or batteries with a new one / new ones?
Rechargeable batteries do not last forever and eventually need to be replaced with fresh ones.
It would help in advising you to know the make and model of your flashlight. To provide that information, you can choose Comment and type the information in the Comment box.
59 views | 0 helpful votes
I have replaced the batteries in 2 duracell 350 flashlights but I can't make them turn on.
the bulbs could be bad, the batteries could be bad, you could have replaced with incompatible batteries or have the wrong orientation. did you realign the compartment to make contact ? often the spot where the batteries go have a wire or metal that connects to another wire or metal when you replace the battery compartment- maybe that metal or wire is not aligned correctly or touching like it should. This was not a question but more of a generalized problem that could have so many solutions. Im not sure more information would have.
25 views | 1 helpful votes
Ozark trail mini lantern. I have replaced the 3a batteries and it still will not light.
Check for reversed batteries and bad battery connections.
Often the problem is corrosion / bad contacts at the battery terminals, especially if used batteries have been left in the device for a while, even if the batteries have not obviously leaked.
Scraping and/or careful cleaning of the device battery terminals will usually fix this. If corrosion is visible then scrub the terminals thoroughly with a bit of vinegar and then strong baking soda (sodium bicarbonate) solution to neutralise alkali and then rinse well with clean water, then dry. Don't let liquid get inside the works, or if that's unavoidable you might have to dismantle and rinse out then dry.
69 views | 0 helpful votes
Not finding what you are looking for?