Blenders - Page 9 - Answered Questions & Fixed Issues

Is probably a binding problem with the motor shaft bearing or the circuit card is fried. If you've tried giving it a good cleaning and that didn't work it's a good bet the unit is junk. Suggest buy a new one.

Go on the Logik blender website and request parts info.

Most small appliances cost more to repair than they are worth. Unless it needs a simple switch or a cord plug it's probably junk. Suggest buy a new device.

Talk to manufacturer they should be able to help.

Best to contact manufacturer if possible or try manualsonline.com :-)

Could you give more info? I have a Bamix with all the accessories so maybe able to help.:-)

My soup maker beeps when I turn it on. I have reduced the liquid etc but makes no difference. The soup is gritty insteD of smooth but it won't pulsate. Now it just keeps beeping.

Most blender / mixers have one safety switch per jug. If your BBL300 has one jug then it should have one small switch where the jug's locking tabs will lock the jug into position. This is usually visible as a small plastic piece (may be black in color) just under an L-shaped groove on the base. This is a "Normally-Open" switch, so that only something pressing the switch lever will switch it on. No jug no work. You need jug. You can test the spindle & motor by switching on (low speed) then use a flat plastic tool (eg a plastic spoon handle) to press this switch tab in. If it starts, motor is good, then you can buy a jug to fit.

Most food processor / mixer / blender models that I've seen work in tandem. On my Salton, for example, start-up runs both the blender / smoothie jug and the larger chopper / slicer on the right. If your model does not have separate controls, then not possible.

The internal rechargeable batteries may have failed. Even when not used, the electrolyte can leak out, weakening the Ah capacity. If not still under warranty, see if you can remove the housing and check if cells have a white, crusty residue, which means they have leaked. If no screws are visible, splitting the two halves of a hand-blender can be a mission - sometimes needing to squeeze one cover-side in a padded vice to release internal hooks.

loose damaged or dried up seal

There could be a build up of rust and/or the grease to lubricate the shaft has hardened and is preventing the shaft from turning. Most likely solution is to disassemble, clean, re-grease and reinstall.

Failed motor or control switch.

Have you turn to other direction or position...? Try again. Good luck Mai

try pulse mode

Put the name and model number into google

You need either a new rubber gasket or the blade is done. Go online and search for the replacement blade using your brand and model number. Easy to replace.

Hi u can order you're parts at this site ::: cheers www.ereplacementparts.com

I found a replacement gasket that work for the GNC on the go Shaker HL-2574 if anyone need some just send me a msg yaz109 hotmail dot com

Yes, you can order the replacement rubber gasket seal ring from nutri Bullet 600w or 900w which is the same size on ebay for $1.00.