Brother HL - Recent Questions, Troubleshooting & Support - Page 8

Push a thick manilla envelope through the area with the machine open to try and get the pieces out. Be careful not to damage the drum unit with rings on your fingers.

it is problem your operating system or driver installation

hi i have brother hl2140 laser printer but all light are blinking give solution how to solve this

Right click with mouse on the print icon in bottom right of pc ,select cancel print in list, then go to printers in control panel and clear all print jobs in your printer list.

Replace the toner cartridge.
There is probably a flaw in the image drum. Replacing the toner will replace the image drum (they are one piece)

please change opc

Hello,

You must reset the drum counter. Check the link where you find how to reset the drum counter http://support.brother.com/g/b/faqend.aspx?c=us_ot&lang=en&prod=hl2280dw_us&faqid=faq00002837_000

Best wishes !

The problem coming because the laser unit in your printer is not working . Need to be replace laser unit to solve the problem.

Try running the internal calibration function a couple of times.

Hello,

Try to search on ebay or amazon for that part.

gan mohon bantuan pencerahannya, di kantor saya memiliki printer LQ 2190 saat ini memiliki kendala lampu indikator merah nyala semua dan printer tidak bisa nge print, itu di sebabkan kenapa ya gan, dan bagaimana cara memperbaikinyamohon bantuan pencerahannya ya gan

Definitely a faulty cartridge. It is probably a build up of toner on the doctor blade or a deformed doctor blade.

Run a self calibration cycle a couple of times, and also clean the laser scanners.

Check the paper being used against what the printer manual recommends. Fan the edges to ensure cut edges are free. Don't use damp paper, ie high humidity may cause drag. Leading edge should be flat, not curled.

Hi,

1. Make sure that the machine is turned on.
2. Open the front cover.
3. Press and hold OK for about two seconds to display Drum Unit, and then press OK.
4. Close cover.

Try cleaning the drum cylinder with alcohol and a cotton ball. Then swipe the corona wire cleaner back and forward making sure to return it to the correct place. Try a print. If it is improved - replace the drum at earliest convenience. If not improved - could be dirty laser lenses or problem with the fuser.

Three or four repeating marks down the page means there will be a spot or smudge of toner on drum unit. Open the front hatch and remover the toner and drum assembly. Separate the toner and drum. Rotate the drum cylinder using the white gear at one end looking carefully at the surface of the cylinder as you turn it. Somewhere on the surface you will see one or more black specks. These need to be cleaned off using alcohol (preferably Iso-propanol but methylated spirit will do)on a cotton ball (or very soft cloth or tissue paper). Once you have found and cleaned off all specks you can re-assemble the toner and drum, put it back in the printer and run a test page. That should fix your problem.

You must have the print drivers installed on you Mac.

Print unable 1A indicates condensation forming inside the machine. If the condensate drops on to the main circuit board (positioned just under a metal bar that acts as a moisture condenser) you have a terminal fault. If your machine is still reporting a 1A error after two weeks in relatively dry conditions, it is probably all over bar the burial ceremony.