Bosch Dryers - Popular Questions, Answers, Tips & Manuals
Bosch Maxx7 sensitive - WTV74100ME/15 - stop after 1 minute , 3 beeps all the time , flushing lights together for heat and open door icon.
The issue you are experiencing with your Bosch Maxx7 sensitive dryer could indeed be related to a faulty heat sensor or a clogged vent. Here are a few troubleshooting steps you can try:
- Check the vent: Ensure that the dryer vent hose is not clogged or blocked. A blocked vent can prevent hot air from circulating in the dryer and trigger the overheat sensor to shut down the machine.
- Clean the lint filter: Remove the lint filter and clean it thoroughly. A clogged lint filter can also cause the dryer to overheat and shut down.
- Check the heating element: If the heating element is faulty, the dryer may not heat properly or may overheat and trigger the sensor to shut down the machine.
- Reset the machine: Turn off the power to the dryer for a few minutes and then turn it back on. This may reset the machine and resolve the issue.
If none of these troubleshooting steps resolve the issue, it may be best to contact a qualified technician to inspect and repair the machine.
12/3/2022 7:37:45 AM •
Bosch Dryers
•
164 views • 0 helpful votes
Bosch gas dryer WTMC6500UC doesn't heat.
It is a gas dryer, it can only be fixed by a registered gas technician. The grinding noise is likely to be bearings or drum rollers. Solenoids click, gas valves work silently, or not at all. Call them out - Imm Besser.
1/9/2022 12:33:22 AM •
Bosch Dryers
•
110 views • 0 helpful votes
My Bosch dryer WTl6500AU/07 is stuck on wrinkle mode
OP Text edited for clarity and spelling. Moved Category from Computers to Bosch Dryers.
This is how you reset. If that doesn't fix it, you will need a service call. It may need a main board, but they are expensive and should not be just changed on a guess.
How to Reset a Bosch Dryer
- Unplug the Bosch dryer from the power supply for 5 minutes and then reconnect to the power supply. Or
- Replace the local fuse or reset the circuit breaker if a fuse or circuit breaker has tripped. Then
- Place items to be dried into the dryer and select a program. ...
- Press "Start/Pause."
More items...
How to Reset a Bosch Dryer ' Hunker
7/4/2021 9:51:10 PM •
Bosch Dryers
•
567 views • 0 helpful votes
Trouble shooting 4100 Bosch motor
Replaced Amateur
Turning switch on trying to turn over ,but will not just a humming sound
Presumably an induction motor rather than a series wound brush type motor?
A single phase induction motor needs help to get started - without help it will just buzz, though it can be started in either direction by manually giving the shaft a vigorous twist...
The starting help is provided by an extra winding (start winding) that provides a phase shift to give the rotor a "kick" in the right direction and then is taken out of circuit. In the early days this was accomplished manually by a switch but later motors incorporated a centrifugal switch on the rotor shaft usually in series with a capacitor.
Lots of modern motors just have the capacitor in series with the start winding resulting in a lighter, cheaper and more compact unit though the capacitor is more highly stressed and fails much more often.
11/22/2019 6:13:46 PM •
Bosch Dryers
•
204 views • 0 helpful votes
Not finding what you are looking for?