Blade Saws - Recent Questions, Troubleshooting & Support


CHECK THE RETURN SPRING

Blade Saws | Answered 3 days ago


sounds like the resistor in the variable speed control is pooched to me...goes open and stops

Blade Saws | Answered on Jan 14, 2019


I am no expert on your saw but on my table saw what I do is block the blade from rotating with a scrap of wood by hooking a tooth on it. Next use a wrench to loosen the blade nut (which is reverse threaded) and simply swap blades.

Blade Saws | Answered on Jan 09, 2019


Just use a very fine blade, it slow but it clean cut don't push the job to fast or you will burn the wood and blade,
Take care.

Blade Saws | Answered on Jan 08, 2019


not a clue here check with the manufacturer

Blade Saws | Answered on Dec 20, 2018


SAME WAY YOU DO ANY SAW BLADE HOLD BLADE FROM TURNING WITH A WOOD BOARD AND USING THE WRENCH PROVIDED WITH SAW . MIGHT BE LEFT HAND THREAD SO TRY BOTH WAYS GENTLY

Blade Saws | Answered on Dec 14, 2018


I think the screw is a left hand thread. To undo, turn clockwise. There is often an arrow. Yes, left hand thread. Bad instructions but see the images.

https://images.rockwelltools.com/en-us/manuals/RK3440K.pdf

Blade Saws | Answered on Dec 09, 2018


Whether a 2 wheel or 3 wheel bandsaw it is more of a hobby to check, care for, adjust and use than any other type of saw.

Assuming the wheels, bearings and guides are all in good condition, the common mistake is to adjust the blade tension so tight it is distorting the casing and wheel geometry, making it impossible to properly adjust the blade tracking.

Blade Saws | Answered on Dec 09, 2018


i HAD THAT PROBLEM AWHILE BACK AND FOUND A TOOTH BROKE ON THE DRIVE GEAR . ORDERED NEW GER AND NOW THE SAW IS IN THE JUNK AS IT STRIPPED THE DRIVE GEAR OF ALL IT'S TEETH THE SECOND USE

Blade Saws | Answered on Dec 08, 2018


you may be pushing to hard..slow down and see if this corrects the issue. otherwise the blade may be slightly askew

Blade Saws | Answered on Nov 16, 2018

Not finding what you are looking for?
Blade Logo

337 questions posted

Ask a Question

Usually answered in minutes!

Top Blade Saws Experts

Kenneth Walker

Level 2 Expert

273 Answers

Cindy Wells

Level 3 Expert

5725 Answers

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

2000 Answers

Are you a Blade Saw Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...