BenQ Computers & Internet - Recent Questions, Troubleshooting & Support

Im not sure but for in some rare circumstances,especially perhaps Benq(they produce niche items as well ) there might be a load up procedure for the operating system--Consult or download theoperators manual for your model--with this manufacturer its too early to say you have no operating system but it also might be the case.

It is possible to bridge to another power supply. There are simple tutorials on YT to help and the process is not very invasive, if you do not wish to harm the current bezel. I was unable to find a switch online to match the model number. Maybe try something close enough to match.

If no issue with other inputs, check the compatibility of the frequencies and refresh speeds.

Go to settings >> system >> About device. Find "Build number" and click 6 times fast on it. Now go to Developer options >> Drawing Section or Rendering Section >> Find "Turn off hardware overlays" or "disable hardware overlays" >> This will force the phone to always use GPU for screen adjustments. no more flickering.

These cables are not different on each brand, they all use the same cable type, so go on eBay and you can find what you need.

a number of things could be wrong- bad ram, bad motherboard. a bad hard drive will still usually get you a post screen. if you are at least getting a post screen, i would look towards hard drive issues.

IgmGuru Offer one of the Best AWS Training online. The AWS Certification exam is intended to efficiently deploy AWS resources to design a solution based on customer requirements. The

Restoring your Joybook to factory default settings: This process will ERASE ALL data on your system drive C: and restore the system to the default factory configuration. If this option is selected, all programs you installed or data you saved on the C: drive will be erased. However, data on the D: drive will not be affected. a. To restore your Joybook to its factory settings, click Full System Restore - Factory default settings under the Restore tab. b. Follow the on-screen instructions to complete the task.

Hi,, try to use the TCPMP player software,, it plays almost every video and audio format... Good Luck!!

Press on the front of the button on top and the battery cover ejects.
When you press the rear of the button it ejects the dongle.

I DID REPAIR A MONITOR WITH THE SAME PROBLEM. IT TURNED OUT, THAT ONE OF THE TWO HIGH TENSION GENERATORS FOR THE 2 LIGHTTUBES WAS BURNED OUT. BY REPLACING THE POWER TRANSISTORS AND THE 3 AMP. FUSE ON THE MAINBOARD THE MONITOR IS RUNNING AGAIN VERY WELL.

most likely he has changed the permissions of the executable file for freecell.

Go to the following location in your pc

C:/Program Files/Games

right click on freecell.exe

Click on the security tab and uncheck the deny fields for every user group.

Click Apply

Click OK

then try to open freecell

just unplug, wait for about 10 or more seconds and it will be fine.

To unlock the OSD

controls when the OSD is

preset to be locked, press

and hold the 'MENU'

button for 15 seconds to

enter the 'OSD Lock'

option and make
changes.

Nigel@netfishers