Avital Vehicle Parts & Accessories - Page 9 - Recent Questions, Troubleshooting & Support

Check if the battery needs replacement.

find the number for honda and explain your problem

please be specific.. details are required..

I would recommend you have a dealership or some kind of professional put that in. those can cause a lot of major problems if installed incorrectly. good luck

Try 2 check all wires r connected - the ignition wire is not connected!!!! Good luck!!!!

The ignition wire has not been wired in2 the system then - try checking all the wires r connected properly!!!! Good luck!!!

How many times is the led flashing after iy shuts down. But my be transponder issue. Or my have not program the bypass module right.

Center top of the windshield, about 2 inches bellow the headliner

Try leaving the key in the ignition (but don't turn it) and then try. If it starts then you need to properly bypass the transponder system. If not then most likely you don't have your ignition and/or start wires hooked up properly. On many cars there is a second starter wire that needs to be connected

Technically you can. Practically speaking though it would take some real skill in electronics. Basically, the lock/unlock outputs are just negative pulses. You would have to pull a circuit schematic and: a) determine the polarity if your wipers b) identify the correct wires c) create a latching relay d) connect everything electrically. If the wiper switch rests at ground, you will have to add a relay

I have installed countless avital systems and have NEVER heard of a whining noise coming from the module. Based on your other comments as well, I would HIGHLY recommend that you visit a qualified install shop to check your work before real damage is done.

A security or transponder bypass.. there are a few different companies that make them.

you can find info herehttp://www.directedstore.com/manuals/477L.pdf

http://www.directedstore.com/manuals/477L.pdf

Depends on the type of remote. Most common fix 1. Take off the lower drivers side kick panel. 2. Locate the black remote box. 3. You should see a thick yellow wire coming from the steering wheel area that has been cut and then spliced to go into the remote box. This is the feed to starter relay and will have voltage when key in in start position.4. reconnect the yellow wire back together bypassing the box. 5. Find the red wire( power source) that goes to box and disconnect it.System should be bypassed

try disconnect battery for 5 min on truck clean computer

lock and unlock