Avanti Refrigerators - Recent Questions, Troubleshooting & Support

My freezer does not work

https://manualsdump.com/en/manuals/avanti-wc1500dss/66172/12 The above has a troubleshooting matrix. Power supply: Check if the wine fridge is receiving power from the mains supply. If it's not, there might be a major issue with the mains power or the PSU circuit board in the product that'll likely need replacing if it's faulty. Condenser fan: The condenser fan is designed to cool the condenser and condenser coil within the Avanti wine cooler. If it doesn't function, the condenser and coil can overheat - causing the internal area of the wine fridge to heat up too. Take a look at the rear of the unit and make sure the condenser fan is spinning freely and not blocked (by dust / dirt) or making excessive noise due debris or a blockage. Thermostat: If the Avanti wine fridge thermostat is working correctly, it's responsible for making the condenser, evaporator, fan, and compressor work - so it's super important! The thermostat also allows you to control and adjust the temperature of the wine cooler so if the reading on thermostat is inaccurate (or flat out wrong) the wine cooler temperature will likely be inaccurate too. Why Is My Avanti Wine Fridge Not Cooling (And How To Fix It) - Expert Wine Storage

If your Avanti WCR683DZD-2 wine cooler's LED panel is blinking when plugged in and neither the fan nor the compressor comes on, there could be a few potential issues. Here are some steps you can take to begin troubleshooting and attempting to repair the unit:

1. Check power supply: Ensure that the wine cooler is receiving power by verifying that the outlet is functioning correctly. Try plugging in another device to confirm if the outlet is working properly.
2. Inspect the power cord: Examine the power cord for any signs of damage or wear. Make sure it is securely plugged into the wine cooler and the power outlet.
3. Check the control board: The blinking LED panel suggests a possible issue with the control board. Inspect the control board for any visible signs of damage, such as burnt components or loose connections. If you are knowledgeable about electronics, you can attempt to repair or replace the control board. Otherwise, it may be best to consult a professional technician or contact Avanti for further assistance.
4. Test the temperature control thermostat: The thermostat controls the operation of the fan and compressor. Using a multimeter, you can check the continuity of the thermostat to determine if it is functioning correctly. If it is faulty, it may need to be replaced.
5. Examine the compressor: Inspect the compressor for any visible issues, such as loose connections or damaged wires. Ensure that it is receiving power and that the compressor motor is not overheating. If the compressor is not running, it may require professional servicing or replacement.

This is Thermoelectric Cooler, so no compressor. Clean around the back where the heatsink and fan is. https://www.manuals.ca/avanti/ewc1201/manual?p=9 Customer Service is on the next page. ..

check the heating element

The single control is what you have to regulate temperature electrically. Variance in temperature is otherwise influenced by how much is contained within (which affects cooling circulation) and how much you keep opening the door. https://settingslab.com/avanti-mini-fridge-settings/

It is probably a K50. https://www.firstchoice-cs.co.uk/ranco-controls/rnck50-p1102

The most likely reason for commercial coolers and fridges not cooling is a low gas state. Did you get your gauges out and check the high and low side pressures before you started swapping parts out?

It is a power supply smd 12 volt 6 A model S 126SMD3 it is craft by www.hanny.com.cn

I had this same problem. I did some troubleshooting and figured out that the fan was being bogged down by ice. It wouldn't spin because the ice was so heavy. I turned the power off completely and let the ice melt. Once the ice was removed from the fan, the fridge began working again!

Drain to freezer, defrost and clean

Usually the vent at the rear of the freezer is blocked with ice. Often caused by a faulty heater or defrost timer. Also check the circulating fan for the fridge. ..

HI David, Please check there: https://manualsbrain.com/en/brands/avanti/fridges/ for a manual. Hope it's helpful

only one and it is " no wine for you"

do not think it is fixable

https://www.manualslib.com/manual/792736/Avanti-Rm3306w.html?page=10

Could be due to control board failure

Is the motor fan working may be getting too hot. Or you may be able to unplug it for a few minutes then plug it back in.

check the switch at back if it is working, check the motor compresor touch the top of the motor comp, if working, the possible problem is the freon, touch the condenser at the back of the unit if hot the freon is working, if no hot, load a freon, ok