Audi Logo

Audi Popular Questions, Answers, Tips & Manuals

Do you work here? Claim your company

  • 559 Products
  • 85K Answers
  • 2M Views

you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single t hing is covered
within seconds u can get the access and it's totally illustrative complete

2004 Audi A4 | 224 views | 1 helpful votes


Will the engine still turn over ? Does it have spark at the plugs ?

2004 Audi A4 | 31 views | 0 helpful votes


located to the rear of the top of the engine next to the radiator reservoir . On top , visible. Two screw.. Phillips or torx. Unplug. remove carefully. Might work if cleaned. Do not use carb. Cleaner. Use alcohol Electric points cleaner, used at radio shops. Wait for it dry . Replace it. Try it. You might want to erase codes beforehand. If no tester available. remove battery cables for a awhile. maybe while doing the removal. If code comes back again, it shouldn't replace it.

Audi Cars &... | 28 views | 0 helpful votes


Catalytic converter problems. A well known issue.

https://www.justanswer.com/audi/77qvj-audi-a4-1998-v6-2-8-quattro-following-fault.html

P1129 Long term fuel trim Bank 2 system too rich
P1127 Long term fuel trim Bank 1 system too rich
Being a turbo check for vacuum leaks especially at the intake, that or the MAF air duct is not secured, This is not going to be with the EGT or 02 sensor unless you left the earth wire for the EGT unsecured. There are vacuum hose that you have to remove or disconnect in order to get to the auxillary water pump. something not on right especially when it affects the exhaust when you start up.There a hose that goes to the turbo intake if that out sure enough you code a rich fuel trim.or with the pressure pipes
Here are the step you would of taken only some are shown.

P1140 MAF Sensor

https://www.autocodes.com/p1141_audi.html

Secondary Air Injection System Incorrect Flow Detected
https://www.engine-codes.com/p0411_audi.html

Audi Cars &... | 25 views | 0 helpful votes


you found the right place buddy.. i know a lot of websites for repairs and manuals that can really help u..
like reliable-store

Audi A6 Cars &... | 31 views | 0 helpful votes


For heavy machinery cars etc. luckily there are many websites
that can help you repair
for eg site like reliable-store is very active in this.. instant help, emails and all that's fantastic

Audi Q7 Cars &... | 29 views | 0 helpful votes


If it was flooded replace the car, the electronics are destroyed, wiring and all.

Audi A6 Cars &... | 29 views | 0 helpful votes


You didn't state the year but could be a couple of issues. First, could have have a cam jump 1 tooth and it is now out of time. Second, you could have a cam or crank sensor failing and they are not syncing. Third, you could have a pcm/ecm failure or issue. Did you get a reference code?

Audi A4 Cars &... | 28 views | 0 helpful votes


There should be instructions in the car handbook for secondary opening system.

Audi Cars &... | 31 views | 0 helpful votes


Hook up a manual gauge to make sure you do have oil pressure

Audi Cars &... | 38 views | 0 helpful votes


Reset radio Audi TT
Use the station buttons 1 through 4 to input the radio code. Press button one repeatedly until you arrive to the correct number (once would be one, twice would be two and so on.) Once you have entered the correct code in the display press the P.SCAN and RBDS simultaneously again, holding down until SAFE is displayed.Apr 24, 2014 https://www.prestigeimports.net/audi-radio-codes-a-complete-guide-from-prestige-imports

Audi Cars &... | 21 views | 0 helpful votes


does it have a headcold??

Audi A4 Cars &... | 29 views | 0 helpful votes


You definitly need to take it to a repair facility with a EURO scan tool.....I would have to hook up to it to see whats happening...

Audi Cars &... | 32 views | 0 helpful votes


Water leak? Coolant leak? Fuel leak?

Audi Cars &... | 23 views | 0 helpful votes


On the 2.8 the starter is located passenger side (underneath), a little back of the Alternator. https://www.audiforums.com/forum/audi-a6-9/changing-starter-c5-4-2-a-178506
The Audi forums is a great place for information, And good luck you'll need it

Audi Cars &... | 34 views | 0 helpful votes


White nail polish. Slap it on the end of your dipstick and you’ll be good to go

2003 Audi A6 | 26 views | 0 helpful votes


I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

Audi Cars &... | 29 views | 0 helpful votes


It will depend on the part you need. New parts are always recommended. You could possibly use mechanical parts from VWs, SKODAs and SEATs as they all use the same parent company.

2006 Audi A4 | 25 views | 0 helpful votes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2002 Audi A4
2002 Audi A4

758 Questions

2004 Audi A4
2004 Audi A4

718 Questions

1996 Audi A4
1996 Audi A4

622 Questions

1998 Audi A4
1998 Audi A4

600 Questions

2001 Audi A4
2001 Audi A4

587 Questions

Top Audi Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Jonah Oneal

Level 3 Expert

14065 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14636 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...