Audi Vehicle Parts & Accessories - Page 3 - Recent Questions, Troubleshooting & Support
What is lambda sensor
The question remained unanswered for almost a year ;
What is a lambada sensor ? >>>>>>>>>>>>>>> Allow me to explain.
The sensor referred to as a Lambada sensor is in fact an Oxygen sensor 02S , it is the key sensor in the engine fuel feedback control .
The engine computer uses the 02 sensors input to balance the fuel mixture . The sensor reacts to unburned oxygen in the exhaust .
Failure of the 02 sensor will result in the fuel consumption rising to about 50% above the normal 14.7-1 air fuel ratio and definitely failing a smog test .
For more free technical 02sensor information pm me
[email protected]
Where is the cam shaft sensor located on a 1998 Mercury Mountaineer 5.0l
Diagrams is not the best on my system. It says towards the rear of the engine but the connector picture shows it close to the front of the car, mid way in the engine. Shows to have a black/white wire and one that shows to be shielded. It has one bolt holding it in place. Hope that helps.
WHAT IS THE CARE OF THE BENCH VICE
Do not pound excessively on it, keep clean of metal filings, rust etc, use a dry lube on the screw that pulls the jaws together, something like graphite, teflon that sprays on and dries works well. Oil will work also but oil collects dirt and after while you need to wash it off and reapply,
Mostly use common sense while using it, the bigger the vise the more abuse it will take, but no vise will take constant beating from a 4 or 8 pound hammer on it.
Hope this helps
How to replace turn signal relay audi A6 1999
Its in the emergency flasher switch both control the same. The emergency flasher button is above the stereo you have to only remove the radio face plate to get at the switch. remove the red triangle button and put it on the new relay part, good luck,Gary
Not finding what you are looking for?