Amana Refrigerators - Page 5 - Popular Questions, Answers, Tips & Manuals

freon is oderless,the gas has no smell to it,what was wrong with the fridge?having sealed system work isn't cheap,was this a new unit?but the gas has no oder

Did U check to see if compressor is running?

Your Manuel should tell you which buttons to push together to reset indicator..

There should be some kind of drain at bottom of freezer compartment to collect and run off any condensate that collects during defrost cycle.. Clean out the drain and snake out the line that leads from it. Right now the liquid is collecting where it should not and it will leak out the gasket when you have enough of it.

Sounds like it could be low on gas (refrigerant). Suggest have a qualified tech test and possibly add more.

Maybe a bad seal.

To get the filter off I think you have to twist and pull

Could it be coming from an ice maker?

Here is the user manual. Go to page 11 for temperature adjustments. http://shared.whirlpoolcorp.com/assets/pdfs/literature/Use%20and%20Care%20Guide%20-%2012642722.pdf

The purpose of a refrigeration circuit is to move heat from the inside of the cabinet to the outside. The compressor pumps refrigerant around the circuit and if everything is ok the evaporator is cold and the condenser becomes warm. If the compressor is running but nothing inside or outside is happening either the compressor is defective or the refrigerant has leaked away. If the condenser is warm or hot but the inside is not cold the defrosting panel might be permanently switched on.

Heaters and defrost timers, and thermal cutouts should be changed at the same time. I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

there's a light or door switch that could be bad,look around and you'll see a switch that the door hits to turn the lights on and off,i've seen people put the bulbs in cross threaded i remove the bulb thread it in and it works try removing the bulb and put it back in again,also if you unplug the machine and stick your finger into the socket there's a metal tab in there that touches the bulb if that is pushed in to far it won't touch the bulb to work bend that out a little and try it again,all there is is the bulb the socket and the switch and the switches are pretty reliable,they're located on the side or up top where the door closes in on the machine

Contact manufacturer for its location,if any.

The water is condensation from the air. It maybe pooling in the wrong place due to blocked drainage in the unit.

The model number on many units are in the Freezer section look there.

lol.. welcome to my world... I have my fridge set at the lowest without turning it off...IT FREEZES a gallon of tea in 5 days!! My freezer ices some.. its set at 3..(1-6).. BUT I like keeping frozen foods FROZEN.. I deal with the ice... I have asked several repairmen.. they just guess...I am NOT going to spend money for something that is a GREAT Frig/Freezer.. better than TOO HOT and ruining food!!

Take back cover off near compressor and maybe front grille at bottom and shine a light to see if you can see what is leaking under unit.

A light switch failure can leave the light on even with the door closed, raising the temp. to over 40 degrees. Firstly, make sure doors are not sagging creating a switch activation with the door closed. If that checks good, replace the door switch. I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

the lighting switch has poblem.

Could be a defrost problem, or faulty door seals, or a freon / sealed system problem.