Amana Logo

Amana Popular Questions, Answers, Tips & Manuals

Do you work here? Claim your company

  • 1K Products
  • 75K Answers
  • 2M Views

It is not switching from cooling into heating. You probably need to have a service tech look at the unit. Sorry. It could be control board or stuck reversing valve.

Amana Heating &... | 218 views | 0 helpful votes


http://www.manualsonline.com/

Amana... | 55 views | 0 helpful votes


Means oven is getting too hot. Replace oven sensor / probe.

Amana Kitchen... | 51 views | 0 helpful votes


fixya doesnt sell products try manufacturer appliance repair shop or online search

Amana... | 398 views | 1 helpful votes


https://producthelp.whirlpool.com/Troubleshooting_Guides/Troubleshooting_for_Top_Load_HE_Washers_(Electronic_Control)/Error_Codes/F%23_E%23_or_F%23%23/F5_E3_Error_code_for_top_load_washers

Amana Washing... | 78 views | 0 helpful votes


Google (amana)(D965E-R)(manual) without parens.

Amana... | 130 views | 0 helpful votes


You can try checking out the installation manual for an idea of how it was installed. It should be sitting on a mounting bracket and not attached to the sheetrock itself. However, you might be pulling on the mounting bracket when you tip it forward. You should have an extra set of hands to help you pull it straight forward and out, instead of tipping it.

The installation manual can be found at https://d1vofmza27mmhi.cloudfront.net/product-pdf/amana-amv1150vaw-installation-instructions.pdf.

Good luck!

Amana Microwave... | 58 views | 0 helpful votes


Make sure that the passage between the freezer and fridge is not blocked

Amana... | 803 views | 0 helpful votes


It will be one of three issues. Blower motor is bad , capicator, or the control board. Easy enough to check . Use an extension cord , cut off the female end and strip it . You should have a black and white wire. Find the wires leading to the motor take the black and white off the control board conect black to black and white to white. Plug it in an outlet if the motor runs its the control board . If not its a bad motor or capicator. But caps rarely go bad in this use . So most likely motor . Not a hard job , but not eady if you dont have the right tools. Do not bang on the shaft with a hammer . You must use a special tool for pulling shafts.

Amana Heating &... | 60 views | 1 helpful votes


Sounds like the load size switch on the control panel is not contacting any position except the small load. Replace the switch.

Amana Washing... | 36 views | 0 helpful votes


ask same question using Google search

Amana Dryers | 583 views | 0 helpful votes


Goodman Industries has purchased Amana. So go to Goodman website for info. Without model number I cannot look up error code

Amana Heating &... | 82 views | 0 helpful votes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Amana Experts

Marvin
Marvin

Level 3 Expert

84524 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Cindy Wells

Level 3 Expert

5828 Answers

Are you an Amana Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...