Amana Popular Questions, Answers, Tips & Manuals

http://s3.amazonaws.com/bobspdf/mn/e/1311039L.pdf

Means oven is getting too hot. Replace oven sensor / probe.

https://producthelp.whirlpool.com/Troubleshooting_Guides/Troubleshooting_for_Top_Load_HE_Washers_(Electronic_Control)/Error_Codes/F%23_E%23_or_F%23%23/F5_E3_Error_code_for_top_load_washers

You have a failed board or sensor. Here is link to error codes. http://www.hvacdist.com/Tech%20Svc%20Bulletins/AMANA/Comfortnet%20Fault%20Codes%20&%20Descriptions.pdf

It is not switching from cooling into heating. You probably need to have a service tech look at the unit. Sorry. It could be control board or stuck reversing valve.

Try moving the selector knob to a different setting. If it doesn't work on another setting, it is most likely the controller itself.

It could be either. You will have to test voltage to burner. If it’s getting voltage to part of burner that’s not working, then burner is bad. If it’s not getting voltage, switch is bad.

Is evaporator fan in freezer running? Is there any frost build up on inside back freezer wall?

https://owners.amana.com/answers/issue-oven-door-wont-unlock/ https://www.youtube.com/watch?v=320yZMp34oA https://www.youtube.com/watch?v=XYeb9J09BVU https://www.youtube.com/watch?v=8M-jlru9MoU

It will be one of three issues. Blower motor is bad , capicator, or the control board. Easy enough to check . Use an extension cord , cut off the female end and strip it . You should have a black and white wire. Find the wires leading to the motor take the black and white off the control board conect black to black and white to white. Plug it in an outlet if the motor runs its the control board . If not its a bad motor or capicator. But caps rarely go bad in this use . So most likely motor . Not a hard job , but not eady if you dont have the right tools. Do not bang on the shaft with a hammer . You must use a special tool for pulling shafts.

could be a bad timer

You can try checking out the installation manual for an idea of how it was installed. It should be sitting on a mounting bracket and not attached to the sheetrock itself. However, you might be pulling on the mounting bracket when you tip it forward. You should have an extra set of hands to help you pull it straight forward and out, instead of tipping it. The installation manual can be found at https://d1vofmza27mmhi.cloudfront.net/product-pdf/amana-amv1150vaw-installation-instructions.pdf. Good luck!

The fuse is located in the heater box. You must pull the back panel off to gain access

Replace the switch for that burner.

https://www.manualslib.com/manual/542212/Amana-D965e.html?page=5 Amana D965E Use Care Manual Check Bucket Indicator Light Fan Speed...

Most likely hit the water supply line to door.

Possibly door switch, start switch, thermal fuse, timer, motor, or wiring.

Probably the control / clock that has a bad bake relay. Replace control.

[email protected] I you would send that I would greatly appreciate it

What is the full model number?