Amana Dishwashers - Page 2 - Popular Questions, Answers, Tips & Manuals

Timer motor's probably bad. Need to be replaced.

FIRST STEP IS TO CLEAN YOUR SUMP AND DRAIN FILTER AND PUMP CHECK FOR NPOISE AFTER CLEANING

Is this a new dishwasher? Many only have a cold water connection. If not new, and it has used hot water previously, it is likely that the solenoid inlet valve on the hot side has failed closed. It will need a service call.

1- water intake is where water supply line is connected to d/w on bottom left be hind kick plate 2-remove spray arm and upper spray tube at same time turning to the right then you will have to use a torx driver to remove sump Cheers

check power connections at d/w power if ok replace concol

Junk in the pump, or debris may make pump wobble. GL

Possible Causes:1) clogged door latch2) door latch solenoid faulty3) PCB Board

hnmmmm contact amana.

Take out bottom rack. loosen and pull out filter. Clean with soap and water. put back in. should drain. http://m.youtube.com/watch?v=OTfBAEmCVDo&desktop_uri=%2Fwatch%3Fv%3DOTfBAEmCVDo

only turn off the breaker from your wall circuit, wait by about 45 seconds. and turn ON again.God bless you

did you check to make sure there is water going to the fridge? It's possible the waterline may be clogged at the saddle valve. does the ice maker cycle? make sure the plug is in correctly and all the way.

Add more rinse aid and check the heater is working. The dishwasher uses steam to dry the dishes.

Great question

The problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into your dishwasher and removes the hard minerals that leave those spots. It is very affordable and even has a money back guarantee. You will love the way your dishes look with this product.

Might need a clean up. click on Maintenance

There is probubally an sensor in the machine that senses salt levels, it is not uncommon for and sensor to be faulty out of the box, I would contact the manufacturers on their 1-800 number nd consult with them and if be order the replacement part from them directly. Hope this helps

see the cause and fix it: God bless youFloat Switch The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Check the tutorial and the video for checking this part. Timer / Control If your dishwasher gets stuck in a cycle first try shutting off the breaker for at least 5 minutes if this does not correct the problem you will need to replace the timer / electronic control.