Question about Water Heaters
temporary filling loop After bleeding the air from a radiator the pressure in the boiler dropped to zero, on the printed label on the boiler it states that the pressure must be between 1 and 2 bar, if
Question about 50 GAL ELEC TALL Water Heater 6YR SC 83VR522
zero, since a failed or open element, will not have low resistance, but rather, with the water as a conductor in a failed condition, will have a higher resistance. You can also check the lower element
Question about 50 GAL ELEC TALL Water Heater 6YR SC 83VR522
...will not fire up for hot water or heating. The pressure guage needle has been returning down to zero for the last few weeks when in standby. I have topped up the pressure to the 1.5 bar setting
Question about 50 GAL ELEC TALL Water Heater 6YR SC 83VR522
...was low today on Greenstar 42CDi. Filled up to 1 bar only to see an hour later that it was back on zero. Turned heating off, blead all rads (some air released but no water??). Re filled to 1 bar, ...
Question about AquaStar 125FXKIT-LP 125FX Liquid Propane Gas Tankless Water Heater w/ Hood
...a fuel to burn. There should be no vent to allow air in as propane is pressurized, and only attains zero pressure at 40 below zero farenheit. The valve you speak of should have been the liquid vent ...
Question about 40 GAL ELEC TALL Water Heater 6YR SC 82VH402
...zero ohms across the 2 terminals. If stat is bad replace stat; disconnect wires push it up out of the spring clip insert new stat reconnect. If element is bad: drain tank. connect garden hose to tank ...
Usually answered in minutes!
335 Questions
282 Questions
267 Questions
250 Questions
267 Questions