Question about 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator
fill up maker but the switch is turned on. Hi: Make sure your freezer is at zero degrees F. It will take 24-72hrs for an ice maker to produce when the freezer is at 0 degrees. Only then will the water
fill on all cycles except rinse, it indicates a cold water supply problem. (Cold water is what is used in the rinse cycle). This normally would be caused by a faulty solenoid on the water inlet valve.
...fill or agitate but will go in spin cycle. Whats wrong with it, is is expensive to get fixed? You most likely have a bad timer. If machine is filling properly, then the switch is bad. Servicing the ...
Question about 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator
...fill tube problem usually caused by water valve not completely shutting off-a drip) May work ok with old valve for a while without replacing also. The next is to test water valve and ice maker by ...
...leads of the pressure switch where the tan and violet wires were connected. You should measure near zero ohms of resistance with the washer full of water. If not, then your pressure switch would need ...
...Take each probe and touch them to one switch terminal each. This should produce a reading of either zero or infinity. Continue to touch the probes to the terminals, and press down on the switch's ...
Question about 16602 / 16604 / 16609 Built-in Dishwasher
...Take each probe and touch them to one switch terminal each. This should produce a reading of either zero or infinity. Continue to touch the probes to the terminals, and press down on the switch's ...
...Take each probe and touch them to one switch terminal each. This should produce a reading of either zero or infinity. Continue to touch the probes to the terminals, and press down on the switch's ...
...Take each probe and touch them to one switch terminal each. This should produce a reading of either zero or infinity. Continue to touch the probes to the terminals, and press down on the switch's ...
...Take each probe and touch them to one switch terminal each. This should produce a reading of either zero or infinity. Continue to touch the probes to the terminals, and press down on the switch's ...
Usually answered in minutes!
1,239 Questions
824 Questions
623 Questions
625 Questions