Questions & Answers for: yth2348 freewheel

primary v-belt , mower , on gth2548 keeps tearing/chunking out i cannot keep the primary v-belt on my gth2548 from tearing up. belt is on/routed properly and deck is adjusted properly. i have been ...

Engine runs good and blades turn fine but the lawnmower does not move forward or reverse. the freewheel control is in the wrong position. push in all the way for mowing. This control is located on the

engine dies when clutch brake released on husqvarna gth2548 Instructions say to purge transmission by setting brake, place in freewheel, start engine, run in slow mode, then release brake. when I ...

YTH 2348 bought new in 2008. Just serviced for season. New battery, oil, fuel, oil, and air filters, plugs, tires, etc.. Fired it up, runs good, but won't go forward, or backward. Freewheel rod is

freewheel lever broken Husqvarna mower- when disengaging lever, it came all the way off. How can we put it back on? Mower won't move until lever is put back in place. For the wire to come all the ...

slow forward I released the transmission in order to push it to point where it could be jumped to start. After starting, I re-engaged transmission with engine running (contrary to later discovered ...