...yamaha-rx-v1500-avr-shuts-down-after-on-for-3-seconds (Wish to deeply thank Daniel Campbell who has discovered this CPR remedy) The solution given here has worked spot on for me. Like a new lease of ...
...YAMAHA products I have never had a problem. If your amp looks like it's going to work as normal (ie the front display lights up as it should etc), but then the amp goes into protection mode when the ...
...protection circuit to trip again). If you can see the display, go to a low level (around -50dB should be fine). Then carefully switch back to the problem source -- if that's the problem, switch off ...
...protection circuit to trip again). If you can see the display, go to a low level (around -50dB should be fine) before the delayed speaker amp output clicks on. Then carefully switch back to the ...
...Yamaha AVR. One more thing is check the is the speaker A/B option. you can see the selection button on the frond panel of your receiver. If the out put of the AVR is ok then you have to check the ...
...Yamaha regarding the reset procedure. They would only say that I had to send to factory for reset. The factory called me upon reciept of my unit and said it had been damaged (dented about 1/4 inch in ...
Question about AVR 340 Receiver
...protection circuit to do its job...protect the speakers. Disconnect all speakers and test HK in all modes (tuner, CD, DVD, etc.) using headphones. If you still cannot hear audio then it's time for a ...
Question about AVR 340 Receiver
...Yamaha RX-V657 without the speaker wire connected, it only stays on for one second and then turns off. No error is displayed on the screen. Is this normal? you forgot to see the AVR works prefectly ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions