...shutting down but never actual shuts down. Question 2 - Everytime I switch it to power save mode and switch back it back "ON" it doesn't print so what I did was I have to restart the RIP. Question 3: ...
Xerox Phaser 8560 warns to replace the maintenance kit in 35 copies. The quality of printing is just fine. Do I really have to replace it now? Thanks for your help. Lisa in Sarasota They sell a lot of
Xerox Workcentre 24- Paper jam in the fuser There is a paper jam in the fuser and the paper is torn. How do I clean this? Shut down. Unplug!!! Remove fuser to remove jam. Fuser may be or be going bad.
Question about M20I Printer
...down immediately. every time Dell 6400 / Vista home basic 80 gig / 2 gig dual core intel Xerox WorkCentre M20i I would first of all Go to the Xerox.com site and go to Drivers and downloads for the ...
...xerox charged me hundreds to just have it restart. What is the proper way to shut it down and restart etc. Hi, there is no real way of shutting these down, but if you remove the fuser and take the ...
Question about DocuColor 12 Color Copier
...Xerox Docucolor 12 Copier/Printer. Tech unplugged & re-plugged internal board connections to find and reset loose connections. Problem was fixed. NOW.... Doc 12 has "forgotten" that it is a ...
...Xerox phaser 7760 printer on it starts to run the warm-up and then shuts down and restarts automatically I had a client with the same problem, wound up having to replace the config chip, nvram chip ...
controller Replace any new toner you put in the machine and shut it down for 2 min then power back on. If that doesn't fix it you will have to call Xerox service to replace a sensor that may be broken
Question about DocuColor 12 Color Copier
xerox 1000 print engine fault codes 42-334 & 42-335 i started running and the machine shut down with these 2 codes print engine fault 42-334 and 42 - 335. What are these codes You can google this ...
Question about DocuColor 12 Color Copier
...Xerox XC1250 copier, the status code H3 indicates a high-temperature error in the fuser section. This error occurs when the fuser unit gets too hot, and the copier automatically shuts down to prevent ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions