washer will not spin i have a hotpoint aquarius wms38 when i put a load in it will fill up with water then nothing happens it will not spin then it emptys the water then fill again for the rinse but ...
washing machine hot point aquarius wms38 how do i remove motor? Is it easy to to remove the panel at the lower rear of the machine you will then see the motor there are two 13mm head bolts remove both
Question about Aquarius WMA42 Front Load Washer
Htptn wma 42 control board on facia wiring diagram(plugs) their are just three plugs that i am quiring they are all two wire plugs(black &black,red&red,and black&blue).on the circuit board starting ...
Question about Aquarius WMA42 Front Load Washer
granddaughter just bought second hand hotpoint aquarius extra wms38 1200 spin .fixed it all up water coming through the ppipes but not in to the machene not filling up or doing anythging any advice ...
Question about Aquarius WMA42 Front Load Washer
my hotpoint wms38 washing machine - when the drum is spinning (not when its 'coasting or winding down', i can hear continuous static sparkling sound. Looking under the machine, I can see continuous ...
Question about Aquarius WMA42 Front Load Washer
my machine keeps stopping and flashing on pre wash.model wms38 1200 spin hi this could be washer not empting properly
Hotpoint wms38 1200 spin motor question I have a Hotpoint wms38 1200 spin about 8 years old (I think). When on full load the drum occasionally slips and there is a high pitch noise when it starts up. ...
Hotpoint Aquarius wms38 1200spin Machine fills with water after wash cycle is finished and it is turned off If the water is coming in after cycle has finished, then it is 1 of 2 possibilities. 1- A ...
Washing machine has died and I dont know how to drain water from drum. HOTPOINT AQUARIUS EXTRA WMS38 hello get a bowl or bucket and position the drain hose a low as possible the water should drain out
Question about Aquarius WMA42 Front Load Washer
...WMS38 Hotpoint washing machine has the wash, rinse and spin and final spin lights on but nothing happens when the start button is pressed Assuming tap water is turned on. If there is no water ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions