Questions & Answers for: Toyota wiring loom

wiring harnesses installed in the corolla are standard looms, you will probably find that you do not have rear speakers installed, however the wires are located beneath the speaker grill by the parcel

how do you change the plug wires on a 1997 toyota 4runner 3.4L V6? u do the plug wires one at a time, never take them all off at once.make sure they are routed exactly like the old wires and that all ...

...wiring loom. Most workshop manuals have a wiring diagram in the back. You would probably find this diagram very confusing as usually they cover mutiple models on the one schematic. The alternative ti ...

...wiring loom somewhere in the boot area, so remove the covers inside the boot area and check over the main wiring loom running down the right or left hand side of the boot. check for wear on the loom ...

short or that one of the wiring plugs has not come loose. Check the wiring loom thoroughly! if you have a owners manual look at it, if not you will need alldata or buy a book at atuo zone for your car

...wiring come across the trunk hinge. Take apart the wire loom for the lights (usually the drivers side) and check for cracked wires. The type of wire on those vehicles were so brittle that they would ...

...wiring loom. A cable which is loomed from the speed sensor can be one colour going in and another colour coming out because Toyota join cables of any colour, presumably for cost effectiveness. The ...

...wiring loom. If u get power with the hazards on re connect the plug and try the same where the bulb goes in. Could also be the connection to the bulbs. If its a faulty plug cut it out and join the ...

...wiring loom. This is on the underside of the steering column and you will have to remove a bit of trim to get to it. What happens is the earth wire connection between the stalk and the loom fails. It ...

wiring loom that is near the collision damage area needs to be checked. I would suggest getting insulation tape black. Then carefully cut the old insulation tape on the loom and see if there is damage