Questions & Answers for: Nissan wiring loom

...wiring in loom at back of engine where main engine harness meets the bulkhead. There is a screened cable grey/pink that houses the two O/S/F ABS wires blue and pink. The loom copex cuts through the ...

...wiring kit for this car, it plugs into a grey connector on the chassis on the rear of the left hand side. this is the connector that the cars rear light loom is plugged into and the towbar loom ...

...does it have a tow bar if so look for wiring tucked away if theres no plug if you mean where to find wires you need to get into rear light wiring loom to connect trailer plug on car to your cars ...

...wiring loom is "different" to that normally used in Almeras and connot identify the correct loom. Did the radio wiring configuration change circa 2003? hi normally nissan use a 1 or 2 plug loom, as ...

I have 2006 Sentra the horn just quit working I have checked the fuses, replaced the relay and checked the wire between the relay and horn. test the horn when disconnected from the wiring loom

Nissan murano 2005/55 needs a new ECU Wiring Loom and Nissan want to charge £3,000. Where can I get an ecu wiring loom? accident damaged vehicle in scrap yard

reverse light wire under the dash need to find where I can connect the revere light wire on my Kenwood receiver so I can trigger it to display camera input from rear camera when I put the car in ...

...wiring loom. you are looking for one or two coloured wires which have been cut and have black wires attached to them. just remove the black wires and rejoin the coloured wires. Should now work

2006. Wires disconnected from underhood fuse box panel. How do I determine which wire connects where? I broke wire harness clip removing underhood fuse box panel to change thermostat. Wires scattered;

...reads etc ? if so this wire may not be required , most vehicle manufacturers will use the same wiring looms on many different models, so some wires/connectors may not be required on every ...