wiring harness and fog light switch just need schematic please help! im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get
unused wires for fog lights The fog lights do not work and there is a cut wire down where the fog lights are. Does this wire do anything could be the + or -for the lights
Fog Lights? Wiring harness has 5 wires from relay, Red to battery, 2 Black - 1 to each light?, 1 Yellow to?, 1 Blue to?, & where do the xtra Black and Green wires go to? These wires are to connect
Question about 2000 F250 Super Duty Crew Cabs
...fog lights in the wiring harness if it did not come with fog lights There may be a connection in the harness or a place to connect the cabling, but what you'll find out is that the light switch is ...
...wire in models that did not come with fog lights in the hyundai tucson no there is no fog light wire but there is a location for the fog lights. You will have to wire it up or get a tech to do
and then to the fog light so that you switch the fog light to on it completes the circuit giving power to the light without digging into your bikes wiring system which can be done later if you want ..
...if by fog lights you mean after market ones., Just takes a switch, wire, 40 amp fuse and 5 pin relay, soldering iron, wiring conduit, sharp edge to bare wire, wiring diagram and some insulation
...switch to the double switch(front an rear fog switch) if you buy this off a scrap car you cut the wiring and connect rear fog plug to bottom of switch and connect front fog wiring to the top
......
Question about 2000 Accord
wiring will now be too light to carry fog light current and or the light switch will burn out To over come this problem, the circuit needs a relay fit a relay on the bike and now run the low beam wire
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions