Questions & Answers for: Oldsmobile Cutlass wiring diagram fuel gauge

Question about 1998 Cutlass

2 Answers

...fuel gauge is stuck under the pin. I had the same problem happen to me. I had to remove the instrument panel and move the gauge back. It's time consuming but it fixes the problem. use a wire through ...

Ad

temp. gauge and fuel gauge does not work. Checked all fuses, appear to be good remove the screws on top of the cluster,remove the plugs and check the printed circuit board for bad soldering

Ad

fuel guage on87 olds cutlass goes past full and will not move down. Check the connection at the tank to see if it is connected.Then take a test light and ground the test light to a good ground.With ...

Question about 1998 Cutlass

1 Answer

fuel gauge reads empty this is caused by a defective fuel gauge sending unit, this sending unit is part of the fuel pump assembly and located inside the gas tank, the tank must be removed to access ...

fuel gauge was working fine until i disconnected the power at the fuse box and hooked up a fuse and power lead for a new stereo that i installed now the fuel gauge is not working right when the car is

...fuel gauge problem relates to the sending unit inside the fuel tank. If the fuel pump has not been replaced in a long time replace the sending unit along with the fuel pump. They are connected ...

...fuel gauge. As the level in the tank drops, the float sinks, the wiper moves, the resistance increases and the amount of current sent back to the gauge decreases. This mechanism is one reason for the ...

fuel tank, if the gauge can move to full when you fill the tank it is good.only way i know how to test the sending unit is to take it out of the fuel tank and hook a meter to the float wires, move the

Question about 1971 Cutlass

1 Answer

wiring diagram All of the dash gauges and warning lights get power from the same pink/black wire. You should have a pink or purple wire coming from the sending unit in the tank that provides ground to

...wiring diagram for your vehicle, says the alternator bat wire goes from alternator to starter solenoid then to positive battery post. The wire from alternator to starter solenoid has fusible link, I ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...